Laserfiche WebLink
� <br /> ;;XXXXXXXXXXXXXXxXXXXxX7cXXXXXXXXXxXXXXXXXXxXXxXXXxxXXxXxXxxXXXXxXXXxXXXXXxXXxXXxXXXxxXXXXX <br /> X <br /> XXXX <br /> Penetrometer and Torque Probe Test Results <br /> (These sections below to be used when applicable. When either is used must be initialled) <br /> xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx <br />, �ocket Penetrometer Test (required if declaring soil bearing pressure greater than 1,000 p.s.f.) <br /> X �� X lS�� X /v�cJ?7 <br /> I <br /> �Testing method <br /> 1. Test the perimeter of the proposed home site at 6 locations as shown. <br /> 2. Take the reading at the depth of the pier pad r�r footer. <br /> � 3, iJsing 500 psf increments, use the lowest reading and round down to that increment. <br /> X l�� � :X ,�� y X �S� <br /> The result of the penetrometer test is �� p s.f. <br /> xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx <br /> Toraue Probe Test (required if using anchors less than 5 feet) <br /> The result of the torque probe test is �� inch pounds. If the test results show 275 incr <br /> pounds or less, 5 foot anchors must be used. <br /> C� (initial) r1 state-approved lateral arm system is being used and 4 ft anchors are allowed at thE <br /> sidewall locations. I understand that 5 ft anchors are required at all centerline tie points where the torquE <br /> test result is 275 inch pounds or less and where the mobile home manufacturer requires anchors with � <br /> minimum 4,000 Ib holding capacity. , <br />, xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx <br /> � declare that I have personally performed the test(s) contained herein and that the reported results <br /> are true and accurate. Date tested 3-17/� (initial) �'� <br /> � <br />