Laserfiche WebLink
These specifications are standards set by the Deparhnent of Highway Safety and Motor Vehicles <br /> for new and used mobile/manufactured homes or park trailers. <br /> (1) Anchors: - <br /> (a) Type I anchor holding power for homes manufactured before July 13, 1994, shall be <br /> tested to a working load of three thousand one hundred and fifty(3,150)pounds,with an ultimate <br /> load of four thousand seven hundred twenty-five(4,725)pounds. <br /> (b) Type II anchor holding power for homes manufactured after July 13, 1994, shall be <br /> tested to a working load of four thousand(4,000)pounds,with an ultimate load of six thousand <br /> (6,000)pounds. <br /> (2) Frame Ties: <br /> (a) All frame ties for new and used mobile/manufactured homes must have a factory <br /> fabricated strap connected at the top of the I-beam to an I-beam clamp approved by the <br /> department pursuant to rules 15C-1.0105 and 15C-1.0107. <br /> (b) Diagonal tie-downs for new and used mobile/manufactured homes, in all wind zones, <br /> shall be spaced no farther apart than five feet four inches(5'4") on center with anchors placed <br /> _ within two feet(2') of each end. Note: Where sidewall strap separation is greater,they must be <br /> tied individually. Each frame tie shall be installed to the component manufacturer's instructions. <br /> (Refer to below drawing) <br /> 14 <br />� _ <br />