16-17664 - Laserfiche WebLink

Browse Search

i � i . ��S�mplEx Non-Addressable Initiating Peripherals UL, CS,FM Listed; FM Approved; Electronic Heat Detectors for . MEA (N;YC) Acceptance* Two-Wire Direct Connect , � � Accura�e thermal detection for protection of - � �`� property** - - - i - �+�: UL liste�d to Standard 521 � Fixed t Imperature operation is suitable for most ``''- � `�f applica�ions: i • Therinistor based design is inherently rate '}'ti�� ;i ��___ ��.,_r,�r compensated due to minimal thermal lag `'� '' % � ��. �fr • Available for 135°F(57°C)or 200°F(93°C) • UL spacing distance is 60 ft Electronic Direct Connect Heat Detector �� Available with rate-of-rise temperature detection: � • Dualithermistor rate-of-rise operation ' - ' ' • For use where anticipated ambient temperature 15 to 32 VDC,filtered DC with changes are less than 6°F/minute Voltage Range 30°/o maximum ripple ' • UL spacing distance is 70 ft standby Current 8o NA nominal Epoxy encapsulated electronic design provides: Up to 100 mA maximum,exact Alarm Current current is determined by alarm • Operation for ceiling or wall mounting current limiting of connected • Easily tested, self-restoring operation with repeatable IDC accuCaCy Meets FM requirements for �� operation between 15°and • Alar indicating LED located on detector Rate-of-Rise Operation u 25° F/min (8.33°and • Current limited alarm that is compatible with 13.88°C/min) two-wire initiating device circuits(IDCs) 10%to 95% RH, not intended Humidity Range j for outdoor applications Direct connecting design: I Storage Temperature 0°to 140° F(-18°C to 60°C) • Wiring attaches directly to detector terminals I Color Off-white • Detector mounts onto mechanical ada ter late P P I�� . Dimensions See dia ram on a e 2 II� (supplied) 9 P 9 ; Ambient Temperature Operating Range 135°F Models 32°to 100° F(0°to 38°C) � " ' • 200°F Models 32°to 150° F(0°to 68°C) � Accurate Electronic Design.Simplex electronic heat deteictors use a fast response,thermistor based design 'This product has been approved by the California State Fire Marshal(CSFM)pursuant to to provide temperature sensing that quickly,accurately, Section 13144.1 of the California Health and Safety Code.See CSFM LisUng 3rid COrislSteritl identifies when fixed tem eratures are �z7a0026:200 for allowable values andlor conditions concerning material presented in y p this document.Accepted for use—City of New York Department of Buildings—MEA35- exceeded.The fixed temperature sensing thermistor 93E.This product was not ULC listed as of document revision date.Addi6onal listings may readily tracks the local ambient temperature.This be applicable,contact your local Simplex product supplier for lhe latest status.Listings °� and approvals under Simplex Time Recorder Co.are the property of Tyco Fire Protection eliminates the time required to melt a lead pellet or heat a Proaucts. bimetall'i�c element as occurs in mechanical heat detector designs and provides the required heat detection for most applications. *'WARNING: In most fires, hazardous levels of smoke Rate-of,l rise detection is determined by comparing and toxic gas can build up before a heat detection p� device would initiate an alarm. In cases where Life two ther�istor responses.By combining accurate Safety is a factor,the use of smoke detection is highly thermistors with proper physical placement,this patented recommended. rate-of-rise detection design achieves a high level of performance not normally available with mechanical detection. i N S4098-0007-13 1/2015 I �