Laserfiche WebLink
�_`'��_.� . <br />---------- - - i��� ' <br /> __TRIP�ii�'Y��E��- ,-- <br /> Alternate Cao Sheet Instatlation Allowances: <br /> The following cap sheets may be i�stalled over sand-top-surfaced SBS-AA or SBS-TA base or ply membranes within asphalt-applied and torch-applied systems noted herein with the noted Maximum Design Pressure <br /> (MDP)limitations. In no case shall the substitution and the associated limitation be used to'increase'the MDP listing in the table;rather if the particular system is less than or equal to the noted cold-cap limitation, <br /> then the substitution fs permitted, <br /> Deck Type System Type listed Cap Sheet Alternate Cold-Cap MDP(ps� <br /> Wood,Steel,Concrete,LWC,CWF, A-2,B-1,B-2,C,D or E SBS-AA or SBS-TA SBS-CA. SBS Cap,SBS Cap UltreWhite,SBS FR Cap,SBS Smooth,SBS Premfum,SBS Premium UltreWhite,SBS _127.5 <br /> Gypsum or Recover Premium FR or SBS Premium FR UltraWhite <br /> Concrete,LWC(over concrete), SBS-CA:S95 Cap,SBS Cap UltraWhite,SBS FR Cap,SBS Smooth,SBS Premium,SBS Premium UltraWhite,SBS <br /> Gypsum or Recover(over concrete) A'1,A-3 or F SBS-AA or SBS-TA Premium fR,S85 Premium FR UltraWhite,SBS Glass,SBS Glass UltraWhite,SBS Glass FR or SBS Glass fR -180.0 <br /> UltraWhite <br /> Concrete,LWC(over concrete), A-1,A3 or F SBS-AA,SBS-TA or A�P- qPP-CA:APP 160 COOL,APP 170 COOL,APP 180 COOL,APP 180 FR COOL or APP 180 FR COOL UltreWhite -225.0 <br /> Gypsum or Recover(overconcrete) TA <br /> 15. "Asphaltic"vapor barrier/temp roof referenced herein refers to 1 or 2 plies Ply IV(4)M or Ply VI(6)M or 1 ply MB Base,SBS Base,SBS Polybase or SBS Premium Base applied in a full mopping of hot asphalt. <br /> 16. "MDP"=Maximum Design Pressure is the resuit of testing for wind load resistance based on allowable wind loads,and reflects the ultimate passing pressure divided by 2(the 2 to 1 margin of safety per FBC 1504.9 <br /> has already been applied).Refer to FBC 1609 for determination of design wind loads. <br /> Exterior Research and Design,LLC.d/b/a Trinity�ERD Evaluation Report F8970.01.08-2-R11 for FL984-R31 <br /> Certifitate of Authorization#9503 Revision 11:04/OS/2015 <br /> Prepared by Robert Nieminen,PE-59166 Appendix 1,Page 4 of 67 <br />