18-20260 - Laserfiche WebLink

Browse Search

Frame Tie to Anchor Anchor Stabilizer If the angle of the frame tie connection is greater All anchors must be properly stabilized to prevent lateral than 500 (as indicated by curved line illustration)), movement of the home and to comply with federal and state the frame tie must be attached to the opposite "r" wind load requirements. beam frame member.45'is the correct angle for this installation. �I eam FP4417e ,� 50°max. jhh,,, (see manufactures in. Installation Instructions) . 45°in line anchor instal- V lation is Ground Level not allowed in Florida. A galvanized Stabilizer Plate of 180 sq. in.must be installed on all anchor/frame be combinations. 1.Refer to any and all federal and state regulations. Use a Soil Test Probe to match eitherType 2 Soil Test Probe anchor location in order to match soil 1,48" or Type 2,60"ground class to ground anchor model. anchor to soil conditions. 3.Partially install anchor at a slight back angle allowing Frame Tie Attachment 14"to 16 to remain above ground level. 4.Utilizing oversize hammer,vertically install stabilizer 1.All frame ties must be attached with a swivel plate,nesting stabilizer plate between anchor and frame. frame connector.Strap must be factory attached to the connecting bracket. 5.Fully install anchor to ground level.Tighten strap, pulling anchor until anchor rod is pre-tensioned against 2.Attach the swivel frame connector beam hook stabilizer plate. to the top of the I-beam from either the front or the back side.The curved or hook end of the beam hook should be snug against the inside top I-beam 5tra Attachment flange. p The strap must be attached to the I-beam by using a beam 3.Attach the swivel connector to the underside of clamp with a swivel connecting bracket.Strap must also be the frame hook with a 1/2" grade 5 bolt and nut factory attached to the connecting bracket. In field crimp This allows the swivel connector to pivot and lock seals are no longer allowed for use on strap to attach to onto the I-beam. frame connectors or hooks. 4.Pull strap past anchor head 10 to 12 inches. Swivel Connector Insert strap into slotted bolt Tighten slotted ten- ® with radius clip. sioning bolt 5 full turns minimum until all slack in ® p #59002&59242 strap is removed(Correct anchor must be installed r , as per ground anchor manufacturer's installation with out strap instructions). o f} 3"Beam Hook#59003 4"Beam Hook#59004 Beam Hook for Dbl.frames ' #59005 N -beam 0 TIE DOWN ENGMEERING - 255 Villanova Drive SW Atlanta, O