18-20300 - Laserfiche WebLink

Browse Search

Tree Tent Program Legend a' A. Power will be provided to tent by using a 1 phase 5 KVA,480 to 240/120 volt Nema 311 step down transformer. This will be placed adjacent to the nearest.parking lot pole that is fed with 480 volt power. The existing load on this circuit is 10 amps and we will temporarily place and additional 3.75 amps on circuit. The breaker size feeding this is 20 amps. B. The transformer is built onto a mobile cart along with a Nema 311240 volt 100 amp single phase load center. This panel contains a 30 amp 2 pole breaker for disconnecting means and will include (2) or (3) 20 amp single pole breakers for GFCI receptacles included on the cart. These will be used to power the lighting and convenience power if required. The transformer will be connected to lighting pole via % seal tight flex: A bare cooper 6 AWG conductor will be wrapped alongside the flex and connected to the ground rod within the pole. This is used as a supplementary ground to the transformer. The cart will also be secured to the concrete pole base with chains. C. A wooden frame or concrete cinder blocks with landscape lumber between will be used to route extension cords from the receptacles to the tent. This helps keep general foot traffic from damaging. D. A web trapeze using clothes line will be built inside the tent to secure the string of lights. The lighting string will be installed to line using plastic tie wraps as not to place the lighting outlets in direct contact with the tent. The string of lights typically is installed at 10 foot after finished floor. Exit signs with battery backup are used at the entry points of the tent. E. The string of lights will consist of two individual strands. Each will have 10 lighting outlets with 60 watt incandescent lamps inserted. The total load will be 60 watts at 10 lighting outlets equaling 600 watts totals. VICTOnBARCLANotaryFoMy ComsMa