18-20025 - Laserfiche WebLink

Browse Search

a Once the ground anchor assembly is fully installed,attach longitudinal and lateral struts according to the diagram under anchor assembly placement(page 1.). The lateral arm fasteners are to be installed tightly(nuts and bolts). The Beam Clamp assembly has two holes for the bolt and nut placement. Depending on the width of the beam,the corresponding hole should be used that pushes the front of the metal plate as close as possible to the upright of the beam. See the illustration on page 2,#5. Lateral struts should be installed in line with the center anchor head and attached at the top of the I-beam. Lateral strut angles must fall within 10 degree minimum-60 degree maximum. Longitudinal strut angles must fall within 10 degree minimum-50 degree maximum. Longitudinal Strut- Longitudinal Strut Attached Point Attached Point FaEing the horne LEFT CORNER Fadng the hoine RIGHT CORNER Lawal strut Lateral Strut Attached Point Attached Point Sidewall Strap - SidewallStrap Connectlon Bonn don After the Lock Down Anchor Assemblies have been fully installed and all permiter anchors and straps fully installed and tightened—each strut has 4 self tapping screws that must be installed as the final step. Predrilled holes are provided on the outer strut indicating placement. If the predrilled holes cannot be accessed, install the screws as close to the predrilled holes as possible-making sure they are tapping into the inner strut. The Lock Down Anchoring System should only be used for homes in the state of Florida. This anchoring system is not designed,tested or approved for use in any other state. Contact Home Pride Inc.276-466-0502 or at contactusCohpanchors.com for any questions concering this product. Legacy Engineering listing#113 Notes: PRODUCT WARRANTY Home Pride warrants its Lock Down Anchor System(HP LDS)against defects in workmanship and material at the site of its initial installation.The HP LDS is specifically designed and approved for use in the State of Florida. This product is not approved for use and should not be used outside the State of Florida. This product must not be reused or reinstalled at any other location. If used in violation of this Warranty or not installed in accordance with installation instructions,all written and implied warranties are void and disclaimed. HP LDS products which are found to have defects will be replaced or repaired at Home Pride's option.This Express Warranty is limited to replacement of product only and does not cover any labor or installations costs. When the product is replaced,all Warranty rights are extinguished.This Warranty is only to the benefit of the original purchaser and is not transferable. There are no other warranties(express or implied)whatsoever which apply to the HP LDS product or to items that are functionally part of the HP LDS product. Home Pride disclaims any and all other implied warranties,including(but not limited to)warranties of habitability,workmanship,materials and fitness for a particular purpose to the extent allowed by law and any implied warranty that exists despite this disclaimer is limited to a period of one(1)year from the effective date of this Warranty. These limitations shall be enforceable to the extent permitted by law. HP LDS products which are examined and are found not to be defective will be returned to user and all costs associated with examination of the anchor product will be incurred by the user. The user is responsible for all maintenance of the HP LDS product including regular monitoring of stability and integrity of HP LDS products. For a warranty claim,contact your distributor or Home Pride Inc.at 15100 Industrial Park Road,Bristol,Virginia,24202. C/�1P> 3. HOME PRIDE