Laserfiche WebLink
- � TAMKO BUILDING PRODUCTS <br /> CREEKAsphalt Shingles <br /> TECHNICAL SERVICES, LLC <br /> INSTALLATION <br /> Elite Glass-Seal® Basic Wind Speed(VUit): Max. 194 mph <br /> (Frederick,Joplin& Basic Wind Speed(Vasd): Max. 150 mph <br /> Tuscaloosa) Deck(HVHZ): In accordance with FBC requirements; <br /> & Solidly sheathed min. 19/32 in. plywood or wood plank for <br /> Glass-Seal new construction; Min. 15/32 in. plywood existing <br /> (Frederick,Joplin (Non- construction. <br /> HVHZ)&Tuscaloosa) Deck(Non-HVHZ): In accordance with FBC requirements; <br /> Solidly sheathed min. 15/32 in. plywood or wood plank for <br /> new construction; Min.7/16 in.OSB existing construction. <br /> Underlayment: In accordance with FBC requirements. <br /> Min.slope: 2:12 and in accordance with FBC requirements. Refer to <br /> the manufacturer's application instructions when installing <br /> shingles at slopes greater than 21:12. <br /> Installation(HVHZ): Installed with 5-1/8 inch exposure in accordance with RAS <br /> 115 and manufacturer's published installation instructions. <br /> Shingles shall be attached using "6 Nail Pattern" detailed <br /> below. <br /> Installation (Non-HVHZ): Installed with 5-1/8-inch exposure in accordance with FBC <br /> requirements and manufacturer's published installation <br /> instructions. Shingles shall be attached using either"4 Nail <br /> Pattern"or"6 Nail Pattern"detailed below. <br /> NAILS <br /> i <br /> ......-..................................-...........----....---------------------------- <br /> Ew alge <br /> Figure 1. Elite Glass-Seal&Glass-Seal <br /> 4 Nail Pattern (Non-HVHZ only) <br /> NAILS <br /> --1" 1" <br /> I- <br /> Nulling - ------------------- - � <br /> Area -------- <br /> -------------------------------------- <br /> ----------------------------- <br /> ------...------------------- <br /> �-1I8" <br /> Butt Edge <br /> Figure 2. Elite Glass-Seal&Glass-Seal <br /> 6 Nail Pattern <br /> TBP15001.4 FL18355-R4 Page 3 of 11 <br /> This evaluation report is provided for State of Florida product approval under Rule tit G20-3. The manufacturer shall notify CREEK <br /> Technical Services,LLC of any product changes or quality assurance changes throughout the duration for which this report is valid. <br /> This evaluation report does not express nor imply warranty, installation, recommended use, or other product attributes that are not <br /> specifically addressed herein. <br />