19-21494 - Laserfiche WebLink

Browse Search

Florida Building Code, Energy Conservation, 6th Edition (2017) Mandatory Requirements for Residential Performance, Prescriptive-and ERi Methods ADDRESS: Permit Number: Zephyrhills,FL, MANDATORY REQUIREMENTS See individual code sections for full details. . SECTION R401 GENERAL . R401.3 Energy Performance Level(EPL)display card(Mandatory).'The building official shall require that an energy performance level(EPL) display card be completed and certified by the builder to be accurate and correct before final approval of the building for occupancy.Florida law . (Section 553.9085,Florida Statutes)requires the EPL display card to be included as an addendum to each sales contract for both presold and nonpresold residential buildings.The EPL display,card contains information indicating the energy performance level and efficiencies of components " installed in a dwelling unit.The building official shall Verify that the EPL display card completed and signed by the builder accurately reflects the plans and specifications submitted to demonstrate code compliance for the building-.A copy of the EPL display card can be found in Appendix RD.' rj R402.4 Air leakage(Mandatory). The building thermal envelope shall be constructed to limit air leakage In accordance with the requirements of Sections R402:4.1 through R402.4.5. Exception: Dwelling units of R-2 Occupancies and multiple attached single family dwellings shall be permitted to comply with Section C402.5. R402.4,1 Building thermal enveto-pbe building thermal envelope shall comply with Sections R402.4.1.1 and R402.4.1.2. The sealing methods between dissimilar materials shall allow for differential expansion and contraction. R402.4.1.1 Instal lation.The components of the building thermal envelope as listed in Table R402.4.1.1 shall be installed in accordance with the manufacturer's instructions and the criteria listed in Table R402.4.1.1,as appiicabie'to the method of construction.Where required by the code official,an approved third party shall inspect all components and verify compliance. R402.4.1.2 Testing. The building or dwelling unit shall be tested and verified as having an air leakage rate not exceeding seven air changes per hour in Climate Zones i and 2,and three air changes per hour in Climate Zones 3 through 8.Testing shall be conducted in accordance with ANSIIRESNET/ICC 380 and reported at a pressure of 0.2 inch w.g.(50 pascals).-Testing shall be conducted by either individuals as defined in Section 553.993(5)or(7),Florida Statutes,or individuals licensed as'set forth in Section 489.105(3)(f),(g)or(i)or. an approved third party.A written report of the results of the test shall be signed by the party conducting the test and provided to the code official.Testing shall be performed at any time after creation of all penetrations of the building thermal envelope. Exception: Testing is not required for additions,alterations,renovations,or repairs,of the building thermal envelope.of existing buildings in which the new construction is less than 85 percent of the building thermal envelope. During testing: 1.Exterior windows and doors,fireplace and stove doors shall be closed,but not sealed,beyond the intended weatherstripping or other infiltration control measures. 2. Dampers including exhaust,intake,makeup air,backdraft and flue dampers.shall be closed,but not sealed beyond intended infiltration control measures. 3.Interior doors,if installed at the time of the test;shall be open. 4.Exterior doors for continuous ventilation systems and heat recovery ventilators shall be closed and sealed. 5.Heating and cooling systems,if installed at the time of the test,shall be turned off. 6.Supply and return registers,if installed at the time of the test,shall be fully open. 0 R402.4.2 Fireplaces. 'New wood-buming fireplaces shall have tight-fitting flue dampers or doors,and outdoor combustion air.Where using tight-fitting doors.on factory-built fireplaces listed and labeled in accordance with UL 127,the doors shall be tested and listed for the fireplace.Where using tight-fitting doors on masonry fireplaces,the doors shall be listed and labeled in accordance with UL 907. R402.4.3 Fenestration air IeakageWindows,skylights and sliding glass doors shall have an air infiltration rate of no more than 0.3 cfm per square foot(1.5 Us/m2),and swinging doors ridmore than 0.5 cfm per square foot(2.6 Us/m2),when tested according to NFRC 400,or AAMA/WDMA/CSA 101/I.S.2/A440 by an accredited,independent laboratory and listed'and labeled by the manufacturer. - Exception: Site-built windows,skylights and doors. •1 r,Ann EnerovGaune0 USA -FSC 6th Edition(2017) Compliant Software Page 1 of 5