Laserfiche WebLink
'Firestone <br /> TECHNICAL INFORMATION SHEET BUILDING PRODUCTS <br /> Heavy Duty Seam Plate <br /> Item Description Item Number <br /> Pail: 1,000 Pieces W56TPOPL03 <br /> Product • • <br /> Description: <br /> Firestone Heavy Duty Seam Plates are specifically designed to be used for the attachment of Firestone UltraPlyTm TPO <br /> Membranes to approved substrates. Firestone Heavy Duty Seam Plates are to be used with Firestone Heavy Duty or All- <br /> Purpose Fasteners into 22 gauge steel, wood or structural concrete decks (Heavy Duty Fasteners only). They may also <br /> be used with Firestone Purlin Fasteners to attach membrane to structural steel purlins. The plates are packaged in a <br /> clear plastic sleeve for easy handling. The sleeve has an easy-open pull tab with serrations that runs the length of the <br /> sleeve. <br /> Product Packaging <br /> Pail: 18 sleeves per pail (1,000 pieces) <br /> Pail Weight: 48 lb(21.8 kg) <br /> Pallet: 40 pails <br /> Methods of Application: <br /> With Screw Gun: <br /> 1. Heavy Duty Seam Plates may be installed with a conventional screw gun. Plates are positioned within the seam <br /> area with"Firestone" logo facing up and the EyehooksTm against the membrane. <br /> 2. The stacked plates allow for the installer to carry fifty-six (56) plates at one time, which are all oriented in the same <br /> direction, making it easier to lay out the plates. <br /> 3. Once placed in the correct seam location, the plate is attached with Firestone All-Purpose, Heavy Duty, or Purlin <br /> Fasteners as appropriate. <br /> With AccuSeamTm Tool: <br /> AccuSeam Tools can be purchased from ITW Buildex. The AccuSeam "boot' attachment can be purchased by owners <br /> of AccuTrac®III tools upon request. Tools with serial number of 12134 or higher are required. Training on the AccuTrac <br /> Tool is recommended prior to use. <br /> 1. Remove the weight from the plate magazine by lifting out. Remove one tube of stacked plates from the pail, and tear <br /> off the perforated edge. This will expose the stack of plates, which are all oriented in the same direction. <br /> 2. Remove and slide the plates into the magazine with the"Firestone" logo facing up, eyehooks facing down. <br /> 3. Replace the weight, and you are ready to start. <br /> 4. Drop a fastener into the feed tube,turn the screw gun on, and push the tool all the way down until the fastener is <br /> properly seated in the plate. <br /> 5. Pull the screw gun back up, move the tool to the next position, drop in your fastener, and repeat step 4. <br /> Firestone Building Products I Sales:(800)42844421 Technical(800)428-4511 1 www.firestonebpco.com <br /> S723-RFS-101 TIS#1108 09/19/2012 <br /> Page 1 of 2 <br />