|
TFPSI
<br /> ` Paige 8 4 of 10
<br /> Note: if prinkler removal becomes If they cannot be completely cleaned Dry Type Sprinklers, 5.6K Pendent,
<br /> necess ,remove the sprinkler using by wiping the sprinkler with a cloth or Upright, and Horizontal Sidewall,
<br /> the $am wrenching method noted by brushing it with a soft bristle brush. Quick Response(3 mm bulb)and Stan-
<br /> above. nklerremovalls easier when .Care must be exercised to avoid lard Coverage spec' the following
<br /> a non-h dening sealant was used Information: g
<br /> and torq a guidelines were followed, damage to the sprinklers befor®,
<br /> Afterrem l in during, and after Instailatlon. S rIr€- •sped the p SIN:
<br /> damage. klers damaged by dropping, striking, Pendent—TY3935 orTY3235
<br /> wrench twist/slippage,or the like,must Sidewall—TY3735 or 1Y3336
<br /> Step 4. fter Installing the ceiling or be replaced.Also,.replace any is Upright—TY3135
<br /> wall and pplying a ceiling finish,slide kler that has a cracked bulb or that has
<br /> on the ou er place of the escutcheon lost liquid from Its bulb.(Ref.Installa- ' 5.6 K factor
<br /> until it cc as in contact with the calling tion Section.) + Deflector Style:
<br /> or wait.D not lift the ceiling panel out The owner is responsible
<br /> of its no al position. for the Upright, Pendent, or Horizontal
<br /> inspection,testing,and maintenance of Sidewall
<br /> When usrrrg the Deep Escutcheon, theirflre protection system and devices ; Quick Response,Standard Cover-
<br /> hold the o er piece in contact with the in compliance with this document, as age,Dry Type Sprinkler
<br /> mounting urface(celling or wail).Then well as with the applicable standards
<br /> rotate the nor place approximately 1/4 of the National Fire Protection Asso- Order length:
<br /> turn with sped to the outer piece, ciation(e.g., NFPA 26), in addition to Dry-Type Sprinklers are furnished
<br /> to hold t e Deep Escutcheon firmly the standards of any other authorities based upon Order length as
<br /> together. having Jurisdiction.Contact the Install- measured per Figures 3 through
<br /> ing oontractor or product manufacturer 10.After taking the measurement,
<br /> Trim and with any questions. round It to the nearest 1/4 Inch
<br /> Automatic sprinkler systems are rec- Increment`
<br /> Wa1 tenance ommended to be inspected, tested, ' Inlet Connections:
<br /> The.TYCO es p$1 pry Typ$Spr1n- and maintained by a qualified inspec- 3/R Inch NPT, I Inch NPT, or ISO
<br /> klers,5.6K Pendent,Upright,and Hori- lion Service in accordance with local
<br /> zontal Sid all,Quick Response(3 mm requirements and/or national codes. • Temperature Rating
<br /> bulb)and ndard Coverage mart be • Sprinkler Finish
<br /> maintain and serviced In accordance J�/�i#@d
<br /> with this s ction. • Escutcheon Style and Finish, as
<br /> Before clo ing a fire protection system Warranty applicable
<br /> main control valve for maintenance For warranty terms and conditions,visit Part Number(P/N)from Table D
<br /> work on a fire protection system www.tyco-fire.com. The Upright Sprinkler without an
<br /> that It con rots, obtain permission to Escutcheon(TY3135)is available in
<br /> shut down the affected fire proteotion Ordering1 Inch NPT only.
<br /> systems m the proper authorities Part Numbers are for 3/4 inch and
<br /> and notifythis
<br /> personnel who may be
<br /> affected 4 Procedure 1 Inch NPT standard order sprin-
<br /> this action. klers.Orders for all other sprinkler
<br /> Absence f the outer piece of an . Contact your local distributor for avail- assemblies must be accompanied
<br /> escutcheo ,which is used to cover a ability.When placing an order,indicate by a complete description.Refer to
<br /> clearanceiole, can delay the time to the full product name and Part Number the Price List for a complete listing
<br /> sprinkler o oration In a fire situation. {PIN). of Part Numbers.
<br /> A Vent Ho a is provided In the Bulb DS-1 Dry-Type Sprinklers Sprinkler Wrench
<br /> Seat(Ref. gures 1 and 2)to Indicate When ordering TYCO Series DS-1 Specify:W Type 7 Sprinkler Wrench,
<br /> If the Dry- pe Sprinkler is remaining P/N 56-850-4-001
<br /> dry.Evlden a of leakage from the Vent Sprinkler Boot
<br /> Hole Indic es potential leakage past Specify Model DSB-2 Dry Sprinkler
<br /> the Inset se i and the need to remove Boot,P/N 63-000-0-002
<br /> the sprinkl to determine the cause of
<br /> leakage(e .,an improper Installation This Part Number Includes one (1)
<br /> or an Ice p g).Close the fire protec- 1300t,two(2)Strap Ties, and 1/3 oz
<br /> tion system control valve and drain the of Adhesive(a sufficient quantity for
<br /> system be re removing the sprinkler._ Installing one boot).
<br /> Sprinklers which are found to �be
<br /> leaking or xhibiting visible signs of
<br /> corrosion ust be replaced.
<br /> Automatic prinklers must never be
<br /> painted, p sled, coated, or other-
<br /> wise altere after leaving the factory.
<br /> Modified sp Inkters must be replaced.
<br /> Sprinklers t at have been exposed to
<br /> corrosive pr ducts.of combustion,but
<br /> have not op rated,should be replaced
<br /> I
<br /> I
<br />
|