20-22532 - Laserfiche WebLink

Browse Search

i ! a ROCK-IT SYSTert"l 4.Q iI'1STEILL i ti -.Xn 1 r q R&A Instal)EcoFasten Solar Flashing with-Rock-It Mounts •Follow EcoFasten Solar Install instructions forflashing and bracket Install(GreenFasten shown above). •Optimum vertical distance behveen lag bolts is 1 3/8',plus module dimension. •Set mounts oneavemostrowsothat the Rock-it Pedestal Is ontheSouthendofRock-itSilde. •Set mounts on all upper rows sothatthe Rodk4t:Pedestal Is on the North end of Rodk4t Slide. 2 Install Rock-It Array Skirt onto Eave Mounts • Slide Rock-it Array Skirt Into front channel on Rock-It Shelf. •.Array Skirt End Caps are pre-Installed on the East end of each skirt'section,and are used t -couple.the skirt sections where needed{see Fig.A}. Tighten Mid-Clamp bolt,damping Rock-lt Array Skirt to mount:Torque to 200 inabs:(1301n-lbs.when Installing with 32mm modules). _4 Instail Rock-it Couplings(when joining 4 panels with a Coupling,the use of a load bearing foot Is required) • Prior to mounting on the roof,snap Load Bearing Foot into the bottom of.Rockdt Coupling if required._ (Each Load Bearing Foot Is set to same height as the Rock-it Mounts-ad)ust accordingly)-. On eave row only,slide Rock-it Array Skirt onto Rock-It Coupling SheltTorque to specified value, • NOTE.If a coupling lands on a rafter,the Hybrid Mount!should be used In place ofthe Rock-It Coupling(refer to image.3a). *Hybrid Mount can be made in the.fleld by assembling a coupling to a mount pedestal;or by purchasing separately. 5Align and Straighten'First Row of the Rock-it System with Rock-It Array Skirt •Use North-Southadjustmerit ofthe Rock4t Pedestal to straighten Rock4t Array Skirt and allgn module with ArraySIdrL •Torque screwon side ofRock-it Pedestal to'150lndbsto secure ttto the RockdtSlide. •Adjust Flange Level Nut to level the system(optional—can be leveled during orafterinstaliaUon}• i 6_9 Install 1 St Row of.PV Modules. •Slide upslope Rock-it Mounts down to engage top offirst module. •install Rock-it Couplings on the upslopestdeof 1st row of paneis. -Torque 2nd row of Mid-Clamps on Rock-@ Mounts and Rock-it Couplings to specified value. •Install balance ofPV modules,ensurin g that the Rock4t Pedestals aye In the appropriate position,then torci ue Mid-Clamps to secure modules. 1-0 Level the Rock-it System -when assemblyls complete;ievel the entire system byadjusting-Flange Level Nuts(Flange Level Nuts have no torque value). • Height between roofsurface and underside of modules should be 3"or less,when Installed with Type 2 modules INSTALLATION NOTE:Modules should.be Installed so that the Junction box is Installed upslope,away.from the leading edge of the array. www.ecofastensolarcom info@ecofastensolaccom 877=859-3947 5 i