20-22591 - Laserfiche WebLink

Browse Search

FORMS TABLE R402A BUILDING COMPONENT PRESCRIPTIVE REQUIREMENTS' INSTALLED VALUES Climate Zone I Climate Zone 2 Windows U-Factor=NR U-Factor=0.40' U-Factor SHGC=0.25 SHGC=0.25 SHGC= Skylights U-factor=0.75 1.1-factor=0.65 U-factor SHGC=0.30 SHGC=0.30 SHGC= Doors:Exterior door U-factor=NR LLfactor=0.401 IJ-factor-- Floors: Slab-on-Grade NR NR Over unconditioned spaces' R-13 R-1 3 R-Value= Walls':Ext.and Adj. Frame R-13 R-1 3 R-Value= Mass Insulation on wall interior R-4 R-6 R-Value= Insulation on wall exterior R-3 R-4 R-Value= Ceilings' R=30 I R=38 R-Value= Air infiltration Blower door test is required on the building envelope to verify leakage<_I ACH; Total leakage=ACH test report provided to code official. Test re ort attached? Yes No El Air distribution systems: Air handling unit Not allowed in attic Location: Duct R-value R-value 2'R-8(supply in attics)or 2t R-6(ail other duct locations) P-Value Air leakages: Duct test Postconstruction test Total leakage<<4 cfm/1 00 s.f. Rough-in test Total leakage 4 cfm/1 00 s.f.(air handier installed) Total leakage cfm/1 OGs.f. Total leakage!�3 cfm/1 00 s.f.(air handier not installed Test report Attached? Yes No F1 Ducts in conditioned space Test not required if all ducts and AHU are in conditioned space Location: Air conditioning system: Minimum federal standard required by NAECAI: Central system 5 65,000 Btu/h SEER 14.0 Room unit or PTAC EER[from Table C403.2.3(3)] SEER Other: See Tables G403.2.3(1)-(1 1) SEE Heating system: Minimum federal standard required by NAECA6: Heat pump 65,000 Btu/h HSPF 8.2 HSPF= Gas furnace,non-weatherized AFUE80% AFUE= Oil furnace,non-weatherized AFUE83% AFUE= Other: Water heating system(storage type): Minimum federal standard required by NAECAI: Elentrie 40 gal:EF=0.92 Gallons= 50 gal:EF=0.90 EF= Gas fired' 40 gal:EF=0.59 Gallons= 50 gal:EF=0.58 EF= Other(describe): NR=No requirement. (1)Each component present in the As Proposed home must meet or exceed each of the applicable performance criteria in order to comply with this code using this method. (2)For impact rated fenestration complying with Section R301.2.1.2 of the Florida Building Code,Residential or Section 1609.L.2 of the Florida Building Code, Building, the maximum Wactor shall be 0.65 in Climate Zone 2. An area-weighted average of 17-factor and SHGC shall be accepted to meet the requirements, or up to 15 square Ceet of glazed fenestration area are exempted from the U-factor and SHGC requirement based on Sections R402.3.1, R402.3.2 and R402.3.3. (3)One side-hinged opaque door assembly up to 24 square feet is exempted from this U-factor requirement. (4)R-values are for insulation material only as applied in accordance with manufacturer's installation instructions. For mass walls, the -interior of wall" requirement must be tuet except if at least 50 percent of the insulation required for the"exterior of wall"is installed exterior of,or integral to,the wall. (5)Ducts&A RU installed"substantially leak-free"per Section R403.3.2.Test required by either individuals as defined in Section 553.993(5)or(7),Florida Statutes,or individuals licensed as set forth in Section 489.105(3)(t),(0 or(i),Florida Statutes.The total leakage test is not required for ducts and air handlers located entirely within the building thermal envelope. (6)Minimum efficiencies are these set by the National Appliance Energy Conservation Art of 1987 for typical residential equipment and are subject to NAECA rules and regulations. For other types of equipment. see Tables C403.2.3(1-1 1) of the Commercial Provisions of the Florida Building Code, Energy Conservation. (7)For other electric storage volumes,minimum EF=0.97-(0.00132*volume), (8)For other natural gas storage volumes,atininiurn EF=0.67-(0.0019*volume). R-56 FLORIDA BUILDING CODE—ENERGY CONSERVATION,6th EDITION(2017)