20-22707 - Laserfiche WebLink

Browse Search

Fire Alarm, Systems I�D8130 Door Module D8130 Door Release Module www.boschsecurity.com BOSCH Invented for life i ► Two Form C (5 A rated) contacts Pi °5r`° ► Remotely controls fire system devices ► Instant or delayed relay activation and restoral oR b 1 s ao r ► Relay closure follows indicating circuit duration ► Disable switch supervised for system testing The D8130 Door Release Module is an accessory for If the user silences the alarm output, the D8130 fire alarm control panels (FACPs) that controls system contacts deactivate. Latching features must be functions commonly required in National Fire provided for pilot relays or contactor units requiring Prevention Association (NFPA) 72 fire alarm control beyond the programmed indicating device time installations. Two independent Form C dry contacts, or after manual silencing of the indicating circuits. each rated at 5 A, connect low-voltage circuits to Supervised Disable Switch magnetic door holders, pilot relays, or contactor units To facilitate fire alarm installation testing, the D8130 for function control. Module contains a supervised disable switch that Typical applications are: prevents operation of the relay contacts. An amber • releasing fire doors, emergency exit doors, and Disable LED indicates when the switch is in the stairwell doors elevator recall disable position. Connect one or more D8130 modules • • HVAC control to any unused 1 kQ zone or point of the control panel to detect module disabling. Functions A trouble is indicated when the D8130 switch is in the disable position, and a restoral signal is sent when the Contact Activation switch is returned to the normal position. (Refer to the The control panel indicating output activates the control panel's Program Entry Guide for details on contacts of the D8130. A red Alarm Input LED programming a trouble signal for an open or short indicates contact activation. condition.) When the contacts are activated with the The duration of the contact activation follows the switch in the normal position, no trouble indications programmed indicating circuit time. Use a jumper to are sent to the control panel. set the contact activation to be instant or delayed by 14 sec when there is an alarm condition. With the Release Contact Outputs delay option selected, a 14 sec delay also occurs upon A normally-open (NO) terminal, a normally-closed (NC) restoral. This delay feature is useful for momentary terminal, and a common (COM) terminal are provided bell tests. for each D8130 contact. In the inactive state of the contact, the NC terminal has continuity with the COM terminal. In the active state of the contact, the NO terminal has continuity with the COM terminal.