21-1413 - Laserfiche WebLink

Browse Search

.ROCK-IT SY STeITI 4.O inSTaLL r' jd. .AQ Fig. A 1. Install EcoFasten Solar Flashing,with Rock-It o'unts •Follow EcoFasten Solar Install Instructions for flashing and bracket install(GreenFasten shown above).. •Optimum vertical distance between'lag bolts Is 13/8'plus,module dimension. •Set mounts on eave most row so that the Rock-It Pedestal[son the South end of Rock-It Slide. • Set mounts on all upper rows so that the Rock-it Pedestal is on the North end of Rock-It-Slide.. 2 Install Rock-It-Array Skirt onto Eave.Mounts Slide Rock-lt Array Skirt into front channel on Rock-It Shelf. Array Skirt End Caps are pre-instal led.on the East end of each skirt section,and are used to couple the skirt sections where needed(see Fig.A). • Tighten Mid-Clamp bolt,"clamping Rock-It Array Skirt to mount:Torque to 2001n4bs.(1301n-lbs.when Installing with 32mm modules). 3-4 Install Rock-It Couplings(when joining 4 panels with a Coupling,the use of a load bearing.foot is-required)- • Prior to mounting on the roof,snap Load Bearing Foot'into the bottom of Rock-it Coupling'if required. (Each Load Bearing Foot is set to same height as the Rock-It Mounts-adjust accordingly) • Oneave row only,slide Rock-It Array Skirt onto Rock-It Coupling Shelf.Torque to specified value. NOTE:If a coupling,lands on.a rafter,the Hybrid Mount*should be used in piace.of the Rock-It Coupling"(refer to Image 3a).. 'Hybrid Mount can be made in the field by assembling a coupling to a mount pedestal,or by purchasing separately. C, Align and Straighten First Row-of the Rock-It System with Rock--It-Array Skirt • Use North-South adjustment of-the Rock-It Pedestal to straighten Rock-It Array Skirt and align module with Array Skirt. •Torque screw on side of.Rock-It Pedestal to 150 in-Ibs.to secure It to the Rock-It Slide. •"Adjust Flange Level Nut to level the system(optional-can be leveled during or after installation): Install.1st Row-of PV Modules 6-9 . Slide upslope Rock-ICMounts down to engage top offirst module. • Install Rock-It Couplings on the upslope side of 1 st row of panels.. •Torque 2nd row of Mid-Clamps on Rock-It Mounts and Rock-It Couplings to specified value. • Install balance of PV modules,ensuring that the Rock-It Pedestals are in the appropriate.position,then torque Mld-Clamps to secure modules. 10 Level the Rock-It System • When assembly is complete,level the entire system by.adjusting Flange.Level Nuts(Flange Level-Nuts have no torque value). • Height between roof surface and underside of modules should be 3'or less,when Installed With Type 2 modules. INSTALLATION NOTE:Modules should be-installed so that the junction box is installed upslope;away from the leading-edge of the array. www.ecofastensolarcom info@ecofastensolar.com 877-859-3947 5