|
CONNECT TO EXISTING WASTE
<br />2" VTR
<br />W
<br />4"
<br />3/4" ! ,/ WC
<br />/ 1 /2"
<br />LAv I1 /2
<br />�• 1 /2"
<br />� 1 /2 LAV
<br />E.W.C.
<br />2" �.
<br />W.C. 1 /2�,` �,�•\3/4"
<br />MOP SINK
<br />WASTE do VENT RISER/HOT A COLD WATER
<br />SCALE: NONE
<br />PLUMBING PLAN
<br />SCALE: 1 /4' = 1'-0'
<br />1/2-
<br />WC
<br />CONNECT TO EXISTING WATER
<br />:XISTING COLD WATER
<br />PLUMBING LEGEND
<br />NEW SANITARY WASTE PIPING
<br />NEW COLD WATER PIPING
<br />NEW HOT WATER PIPING
<br />— — v — — — v — — NEW VENT PIPING
<br />RD NEW ROOF DRAIN PIPING
<br />pd GLOBE SHUTOFF VALVE
<br />PLUMBING SPECIFICATIONS
<br />PROVIDE ALL LABOR, MATERIALS, AND EQUIPMENT REQUIRED FOR A COMPLETE
<br />9. WATER HEATERS
<br />SYSTEM AS OUTLINED IN THE CONTRACT DRAWINGS AND THESE SPECIFICATIONS.
<br />A) PROVIDE ISOLATION VALVES AT THE INLET AND OUTLET OF ALL
<br />NOTE THAT DRAWINGS ARE DIAGRAMMATIC ONLY AND INTENDED TO SHOW THE
<br />WATER HEATERS.
<br />GENERAL ARRANGEMENT OF SYSTEMS, NOT EVERY MINUTE DETAIL. PROVIDE ALL
<br />B) PROVIDE A SEPARATE DISCONNECT SWITCH FOR ALL ELECTRIC
<br />NECESSARY FITTINGS, TRANSITIONS, CONNECTORS, ETC. WHETHER SHOWN OR NOT
<br />WATER HEATERS OR A GAS SHUTOFF VALVE FOR ALL GAS WATER
<br />ON PLANS. ALL WORK SHALL CONFORM TO THE FOLLOWING CODES (AS
<br />HEATERS.
<br />APPLICABLE) AS WELL AS ALL LOCAL REGULATIONS, ORDINANCES, AND
<br />AMENDMENTS :
<br />10. VALVES & ACCESSORIES
<br />2004 FLORIDA BUILDING CODE
<br />A) PROVIDE WATER HAMMER ARRESTORS OR AIR CHAMBERS AS
<br />REQUIRED TO ELIMINATE WATER HAMMER AND COMPLY WITH LOCAL
<br />2. SCOPE OF WORK
<br />REGULATIONS.
<br />PROVIDE PLUMBING SYSTEM AS SHOWN AND CONNECT TO EXISTING SYSTEM
<br />B) PROVIDE A MAIN SHUTOFF VALVE AT THE BUILDING'S DOMESTIC
<br />DESCRIBED BY THESE DOCUMENTS.
<br />WATER SERVICE ENTRANCE.
<br />C) PROVIDE MANUFACTURED PIPE HANGERS, RODS, AND INSERTS OR
<br />3. ITEMS FURNISHED BY CONTRACTOR
<br />FOR THE PROPER SUPPORT OF ALL PIPING. BAND IRON, TIE
<br />IT SHALL BE THE RESPONSIBILITY OF THE CONTRACTOR TO PROVIDE ALL IT
<br />WIRE, OR WIRE STRAPPING ARE NOT ACCEPTABLE. ALL PIPES SHALL
<br />MATERIALS, EQUIPMENT, AND ACCESSORIES NECESSARY TO MAKE A COMPLETE
<br />BE SUPPORTED AT REGULAR INTERVALS. PIPE SWAY AND/OR
<br />INSTALLATION. ALL EQUIPMENT SHALL BE STORED IN A SAFE, DRY PLACE IN THE
<br />VIBRATION SHALL NOT BE ACCEPTABLE. DO NOT HANG PIPING FROM
<br />VI
<br />MANUFACTURER'S ORIGINAL PACKAGING UNTIL READY FOR USE. THE OWNER SHALL
<br />ANYTHING OTHER THAN THE BUILDING STRUCTURE.
<br />NOT BE RESPONSIBLE FOR PROVIDING ANY PART OF THE PROJECT, UNLESSAPPLY
<br />MIN. 20 MILS
<br />INS
<br />SPECIFICALLY NOTED. THE CONTRACTOR SHALL ALSO BE RESPONSIBLE FOR PAYING
<br />TAPE COVERING OVER ALL STEELORCOPPER( WATERUPIP NG
<br />ALL REQUIRED FEES, OBTAINING ALL PERMITS, AND ARRANGING FOR ALL
<br />CONTACT WITH MASONRY OR CONCRETE.
<br />INSPECTIONS.
<br />E) PROVIDE CHROME PLATED ESCUTCHEONS WHERE PIPES
<br />PENETRATE ANY EXPOSED WALLS, PARTITIONS, ETC. TO COVER THE
<br />4. COORDINATION
<br />ALL WORK ON THIS PROJECT SHALL BE COORDINATED WITH ALL OTHER TRADES.
<br />PENETRATION.
<br />F) PROVIDE VACUUM BREAKERS WITH ALL HOSE BIBBS, SILLCOCKS,
<br />CONTRACTOR SHALL REVIEW PLANS OF ALL DISCIPLINES INVOLVED AND ADVISE
<br />THE ARCHITECT IN WRITING OF ANY CONFLICTS, CODE OR SAFETY ISSUES THAT
<br />OR HYDRANTS.
<br />MAY EXIST PRIOR TO ANY FABRICATION OR ORDERING OF EQUIPMENT. PROVIDE
<br />ROUTING AND OFFSETS NECESSARY TO AVOID CONFLICTS WITH STRUCTURE,
<br />FINISHES, AND WORK OF OTHERS. CONTRACTOR SHALL PROVIDE ALL CORE
<br />11. FIXTURES
<br />A) FIXTURES HAVE BEEN SELECTED TO ESTABLISH A STANDARD OF
<br />PENETRATIONS AND PATCHING FOR PIPING FLOOR PENETRATIONS.
<br />QUALITY AND SUBSTITUTIONS ARE NOT PERMITTED UNLESS SUBMITTED
<br />AND APPROVED PRIOR TO USE.
<br />5. PLUMBING GENERAL
<br />B) ALL VITREOUS CHINA FIXTURES SHALL BE WHITE UNLESS
<br />A) ALL PLUMBING SERVICES TERMINATE 5'-0" FROM THE BUILDING EXTERIOR
<br />OTHERWISE NOTED.
<br />WAS.
<br />C) SEE ARCHITECTURAL PLANS FOR EXACT FIXTURE LOCATIONS AND
<br />B) NO LEAD OR ASBESTOS CONTAINING MATERIALS OF ANY KIND SHALL BE USED
<br />MOUNTING HEIGHTS.
<br />IN THE FABRICATION OF POTABLE WATER SUPPLY SYSTEMS. GALVANIZED STEEL
<br />D) INSTALL HOT WATER SUPPLY ON THE LEFT SIDE OF ALL
<br />PIPING SHALL NOT BE USED FOR POTABLE WATER SUPPLY PIPING.
<br />FIXTURES
<br />C) INSTALL ALL WORK IN COMPLIANCE WITH ADA REQUIREMENTS.
<br />E) PROVIDE LAVATORY CARRIERS WITH ALL WALL MOUNTED
<br />D) THE MAXIMUM HOT WATER SUPPLY TEMPERATURE SHALL NOT EXCEED 115 F.
<br />LAVATORIES. CARRIERS SHALL WITHSTAND A MINIMUM VERTICAL LOAD
<br />E) PROVIDE "P" TRAPS WITH CLEANOUTS IN THE DRAINS OF ALL FIXTURES EXCEPT
<br />OF 250 POUNDS ON THE FRONT OF THE FIXTURE.
<br />THOSE WITH INTERNAL TRAPS OR AS SPECIFICALLY NOTED ON PLANS.
<br />F) PROVIDE PROTECTIVE ANTI —MICROBIAL INSULATION ON THE
<br />F) ALL PIPING SHALL BE CONCEALED IN WALLS, CHASES, CEILINGS, ETC. UNLESS
<br />SUPPLY SET AND WASTE DRAIN AND TRAP OF ALL HANDICAPPED
<br />SPECIFICALLY NOTED ON DRAWINGS. ANY PIPING OR ACCESSORIES THAT MUST BE
<br />LAVATORIES.
<br />EXPOSED SHALL HAVE A POLISHED CHROME FINISH.
<br />G) ALL WATER CLOSETS SHALL BE THE ELONGATED TYPE WITH OPEN
<br />G) COORDINATE THE ELECTRICAL CHARACTERISTICS OF ALL ELECTRICAL EQUIPMENT
<br />FRONT SEATS.
<br />WITH THE ELECTRICAL CONTRACTOR PRIOR TO ORDERING.
<br />H) PIPING SHALL NOT PASS THROUGH DUCTWORK OF ANY KIND UNLESS
<br />12. PENETRATIONS
<br />A) ALL PENETRATIONS THROUGH RATED WALLS OR FLOORS SHALL BE
<br />APPROVED BY THE ENGINEER.
<br />SEALED WITH AN APPROVED FIREPROOFING TO MAINTAIN THE
<br />6. SANITARY WASTE. VENT, AND STORM DRAIN PIPING
<br />INTEGRITY OF THE WALL OR FLOOR.
<br />A) ALL SANITARY WASTE, VENT, AND STORM DRAIN PIPING SHALL BE SCHEDULE
<br />B) ALL PIPING PASSING THROUGH BUILDING STRUCTURE OR RATED
<br />40 PVC.
<br />WALLS OR FLOORS SHALL BE SLEEVED.
<br />B) ALL SANITARY WASTE PIPING SHALL BE SLOPED AT NO LESS THAN 1 /6" PER
<br />13, WARRANTIES AND MAINTENANCE
<br />FOOT.
<br />C) VERIFY LOCATIONS AND INVERT ELEVATIONS OF ANY AND ALL EXISTING WASTE,
<br />A) ALL FIXTURES SHALL BE TESTED, CLEANED, AND PLACED IN
<br />GOOD OPERATING CONDITION BY THE CONTRACTOR. CONTRACTOR
<br />VENT, AND STORM DRAIN PIPING PRIOR TO BEGINNING ANY WORK.
<br />SHALL GUARANTEE ALL EQUIPMENT, MATERIALS, AND WORKMANSHIP
<br />TO BE FREE OF DEFECTS FOR A PERIOD OF ONE YEAR FROM THE
<br />7. DOMESTIC WATER PIPING
<br />A) ALL DOMESTIC WATER PIPING ABOVE GROUND SHALL BE TYPE "L" COPPER
<br />DATE OF ACCEPTANCE BY THE OWNER AND THE CONTRACTOR SHALL
<br />REPAIR ANY SUCH DEFECTS AT NO COST TO THE OWNER. ALL
<br />WITH WROUGHT COPPER FITTINGS AND LEAD FREE SOLDER JOINTS.
<br />EQUIPMENT INCLUDED IN THE PROJECT SHALL BE COVERED BY THE
<br />B ALL HOT WATER SUPPLY PIPING SHALL BE INSULATED WITH 1" THICK, MIN.
<br />MANUFACTURER'S WARRANTY FOR THE DURATION OF THAT WARRANTY.COPIES
<br />R-6, CLOSED CELL FOAM INSULATION (ARMAFLD( OR EQUIVALENT).
<br />OF ALL MANUFACTURER'S WARRANTIES AND CONTRACTOR
<br />WARRANTIES SHALL BE PROVIDED TO THE OWNER AT FINAL
<br />8, VENTS
<br />ACCEPTANCE.
<br />A ALL TRAPS OR TRAPPED FIXTURES SHALL BE PROVIDED WITH AN INDIVIDUAL
<br />B) CONTRACTOR SHALL RECORD DRAWINGS DURING CONSTRUCTION
<br />VENT UNLESS OTHERWISE NOTED.
<br />AND NOTE OF ANY OFFSETSOTHER DEVIA FROM
<br />NS
<br />B) PLUMBING VENTS SHALL NOT BE LOCATED LESS THAN 10'-0" FROM ANY
<br />THE ORIGINAL COONTRACT DOCUMENTS. ATOTHE CLOSE OF THE
<br />OUTSIDE AIR INTAKE, WINDOW, OR DOOR.
<br />PROJECT, CONTRACTOR SHALL PROVIDE A COPY OF THESE DRAWINGS
<br />C) OFFSET ALL VTR'S AS REQUIRED WHETHER SHOWN OR NOT ON DRAWINGS.
<br />TO THE OWNER AS "AS—BUILTS".
<br />D) PROVIDE ALL VTR'S WITH 4 LB. HIGH BOOT LEAD FLASHING OR AS REQUIRED
<br />BY THE ROOFING MANUFACTURER. FLASHING SHALL EXTEND UPWARD AROUND THE
<br />PIPE AND TURN DOWN INSIDE THE PIPE.
<br />HEAT
<br />TRAP
<br />VACUUM BREAKER
<br />36 WATTS OR EQUAL
<br />T & P RELIEF
<br />VALVE
<br />3/4" COPPER
<br />TO PAN I�
<br />i
<br />COLD WATER
<br />SUPPLY ---
<br />EXPANSION TANK
<br />SERVICE
<br />—DRAIN VALVE
<br />It, 1 1 /2" EDGE
<br />SAFETY PAN
<br />EXTERIOR OR
<br />MOP SINK
<br />CATER HEATER INSTALLATION
<br />SCALE: NONE
<br />* TO THE BEST OF THE ARCHITECT OR ENGINEERS KNOWLEDGE AND
<br />BELIEF, THESE PLANS AND SPECIFICATIONS COMPLY WITH THE
<br />FLORIDA BUILDING CODE 2004 4 2005, 2006 5UPPLEMENTS
<br />' THE O WIN66 4 OM16N ARE VALID FOR 12 MONTHS FROM DATE
<br />OF BEING SEALED.
<br />TO THE BEST OF THE KNOWLEDCsE OF THE ARCHITECTS OR
<br />ENGINEERS, SAID PLANS AND SPECIFICATIONS COMPLY WITH THE
<br />APPLICABLE MINIMUM BUILDIWS CODES AND THE APPLICABLE
<br />MINIMUM FIRE SAFETY STANDARDS.
<br />ALL DIMENSIONS AND JOB CONDITIONS SHALL BE VERIFIED BY THE
<br />CONTRACTOR, ANY AND ALL DISCREPANCIES SHALL BE REPORTED
<br />TO THE ARCHITECT PRIOR TO COMMENCEMENT OF CONSTRUCTION.
<br />13811E DATE BYs
<br />REvIEW Orin1/08 MK
<br />PERMIT 01AII08 MK
<br />REV
<br />REV.
<br />REV.
<br />REV.
<br />TICIE DOA0M8 M DE WA VOM DETAU NO
<br />810601ROATIM ND C442 IS ARE 7W SOLE
<br />PROP M OF MtAZ 00ft W. Mo SOU Wr BE
<br />wIllm om, RE i m OR OOPm Fat onee
<br />MWZ07% M MW OR PART MT W M Mil =
<br />WOW OF FRANC PitM AWHIMT, Alk
<br />ALL MGM ARE ItESmkm Or ME AWAMT M
<br />AC40MWM M rH US. WPfR1W NO PAM LAMS.
<br />UNFUTHOItl� R�RODUGTION MLL � PR09EGJIm TO
<br />TIE MLL Ex W OF 7W LW
<br />S
<br />o�
<br />00
<br />v 1
<br />W
<br />W
<br />�
<br />Q
<br />O
<br />Nxx
<br />0
<br />L7
<br />N
<br />11 ORA PRAWLIN FRAZE, IV j
<br />'00
<br />0
<br />�
<br />�
<br />M
<br />t`
<br />QONO
<br />r`
<br />U
<br />(Yi
<br />a
<br />00
<br />W
<br />W
<br />ao
<br />N
<br />N
<br />r
<br />w
<br />W
<br />Z
<br />W
<br />U
<br />00
<br />00
<br />�
<br />F
<br />�
<br />W
<br />eq
<br />�
<br />b
<br />..uz
<br />O
<br />x
<br />�T TITLE
<br />PLI.A"IE�ING
<br />I PLANS
<br />Bic
<br />
|