360 S Rosemary Ave Ste 400 (2) - Laserfiche WebLink

Browse Search

SpectrAlert Advance Outdoor Horn, Strobe, and Horn StrobeSpecifications teen;,. s! SpectrAlert Advance outdoor horns strobes, and 'horn strobes shall mount to a weatherproof back box. A universal mounting plate shall be used for mounting ceiling and wall products. The notification appliance circuit wiring shall terminate at the universal mounting plate. Also, SpectrAlert Advance products. when used with the Sync•CircuitTm Module accessory, shall be powered from a non -coded notification appliance circuit output and shall operate on a nominal 12 or 24 volts. When used with the Sync•Circuit Module, 12-volt-rated notification appliance circuit outputs shall operate between 8.5 and 17.5 volts; 24-volt-rated notification appliance circuit outputs shall operate between 16.5 and 33 volts. Outdoor SpectrAlert Advance products shall operate between -40 and 151 degrees Fahrenheit from a regulated DC or full - wave rectified unfiltered power supply. Strobes and horn strobes shall have field -selectable candela settings including 15, 15/75, 30, 75. 95, 110, 115, 135, 150. 177. and 185. Strove The strobe shall be a System Sensor SpectrAlert Advance Model listed to UI 1971 and shall be approved for fire protective service. The strobe shall be wired as a primary -signaling notification appliance and comply with the Americans with Disabilities Act requirements for visible signaling appliances. flashing at 1 Hz over the strobes entire operating voltage range. The strobe light shall consist of a xenon flash tube and associated lens/reflector system. The strobe must be installed with its weatherproof back box in order to remain outdoor approved per UL. The strobe shall be suitable for use in wet environments. Horn Strobe Combinabon The horn strobe shall be a System Sensor SpectrAlert Advance Model listed to UL 1971 and UL 464 and shall be approved for fire protective service. The horn strobe shall be wired as a primary -signaling notification appliance and comply with the Americans with Disabilities Act requirements for visible signaling appliances flashing at 1 Hz over the strobes entire operating voltage range. The strobe light shall consist of a xenon flash tube and assocated lens/reflector system. The horn shall have three audibility options and an option to switch between a temporal three pattern and a non -temporal (continuous) pattern. These options shall be set by a multiple position switch. On four -wire products, the strobe shall be powered independently of the sounder. The horn or horn strobe models shall operate on a coded or non -coded power supply. The horn strobe must be installed with its weatherproof back box in order to remain outdoor approved per UL. The horn strobe shall be suitable for use in wet environments Operating Ten : -40°F to 151 °F (-40°C to 66�C) Strobe Flash f1a � 1 flash per second Nominal Voltage Regulated 12 DC/FWR or regulated 24 DC/FWR' Operating'Voltage Ran . 8 to 17.5 V (12 V nominal) or 16 to 33 V (24 V nominal) Operating Volts with NI. 3 3 8.5 to 17.5 V (12 V nominal) or 16.5 to 33 V (24 V nominal) InputTermirial Wi>e Gau-4o 12 to 18 AWG Wall -?`'natant Dirne wp-' , 5.6-L x 4.7" W x 2.5-D (142 mm L x 119 mm W x 64 mm D) Horn Dimensiom 5.6"L x 4.7"W x 1.3"D (142 mm L x 119 mm W x 33 mm D) Wall-MountWeatherrsroof S,,t c>.r Ct11 ar , (SA-WSS 5.7'"L x 5.1""W x 2.0-D (145 mm L x 130 mm W x 51 mm D) Notes. 1. Full Wave Rectified (FWR) voltage is a non -regulated, time -varying power source that is used on some power supply and panel outputs 2. 2. P, S, PC, and SC products will operate at 12 V nominal only for 15 and 15/75 cd. AVD5115-02 • 12i3r2019 • Paye 2