Laserfiche WebLink
II <br />FIRE CONTROL <br />INSTRUMENTS <br />by Honeywell <br />Description <br />The Digital Alarm Communicator Transmitter (DACT-E3) is <br />an optional component of the E3 Series® Expandable <br />Emergency Evacuation System. The DACT-E3 sends digi- <br />tal signals over the telephone network to a central station. <br />This module can be located in the main cabinet or remotely <br />located via a local RS-485 serial interface. <br />The DACT-E3 is compatible with digital alarm communica- <br />tor receivers (DACRs) that receive the following signaling <br />formats: <br />• SIA DC8 3+1 2300 Hz <br />• SIA DCS20 4+2 1400 Hz <br />• Ademco Contact ID 4+2 2300 Hz <br />• 3+1 1400 Hz <br />In addition to the DACT-E3 being compatible with digital <br />signaling formats, the DACT-E3 features numerous for- <br />mats for communication to a central station. As a digital <br />communicator, the DACT-E3 complies with FCC Part 8, <br />Telecommunication Standards for DC and AC Ringer <br />Equivalence. <br />Installation Instructions <br />The DACT-E3 is adaptable for installation in standard E3 <br />Series° System cabinets. Typically, the DACT-E3 module <br />mounts on standoffs on top of the left side of the ILI-MB- <br />E3/ILI95-MB-E3 module. Either unit can be easily con- <br />nected to the backbox or sub -assembly plate depending on <br />the cabinet module. <br />Note: For instructions on installing the DACT-E3, refer to <br />the E3 Series® Expandable Emergency Evacuation Instal- <br />lation/Operation Manual, Part Number: 9020-0574 or the <br />DACT-E3 Installation Instructions Part Number:9000-0581. <br />Specifications <br />Operating Voltage: 24 VDC (from the PM-9/PM-9G <br />power supply) <br />Operating Current: 0.018 amp <br />Alarm Current: 0.018 amp <br />Operating Temperature: 32' to 120' F (0 to 490 C) <br />Relative Humidity: 0 to 93%O, non -condensing at <br />90° F (32° C) <br />E3 Serieso and NetSOLO" are registered trademarks of Honeywell International Inc. <br />UL@ is a registered trademark of Underwriters Laboratories Inc. <br />BACTmE3 <br />Digital Alarm <br />Communicator Transmitter <br />DACT-E3 <br />Features <br />• Listed under UL® Standard 864, 9th Edition <br />• Communicates with the E3, ILI-MB-E3/ILI95-MB-E3 <br />sub -assembly via RS-485 <br />• Communicates in a variety of formats (including full <br />Contact ID) <br />• Transmits and verifies data to the central station <br />• Offers pre-programmed dialing to the central station <br />phone number <br />• Performs on and off -hook status to the phone lines <br />• Traces proper central station "ACK" and "Kiss -off' tone <br />• Activates hang-up and release phone lines <br />• Compatible with the IPDACT Internet Communicator <br />Ordering Information <br />Part Number Description <br />DACT-E3 Digital alarm communicator transmitter <br />An ISO 9001-2000 Company <br />SIGNALING <br />U� FM <br />3, P ciry"r <br />MEA <br />cn city m <br />LISTED arvR . Approved <br />Approved Denver <br />s1869 3025415 FDNY: <br />7165-1703:0125 0, 1 Approved <br />COA N6077 <br />CI-2 <br />High R, <br />GAMEWELL-FCI <br />12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118 <br />Specifications are for information only, are not intended for installation purposes, and are subject to change without notice, No responsibility is assumed by Gamewell-FCI for their use. <br />©2011 by Honeywell International Inc. All rights reserved. www.gamewell-fci.com 9020-0610 Rev. I page 1 of 1 <br />