Laserfiche WebLink
<br />** ~NFILTRATION REDUCTION PRACTICE COMPLIANCE CHECKLIST ** <br /> <br />================================================================:=============== <br /> <br />:OMPONENTS <br /> <br />SECTION <br /> <br />REQUIREMENTS FOR EACH PRACTICE <br /> <br />CHECK <br /> <br />:===============================================================:=============== <br /> <br />'RACTICE #1 <br /> <br />J i ndows <br /> <br />:xter ior & <br />\djacent Doors <br /> <br />:xter ior Joi nts <br />( Cracks <br /> <br />'RACTICE #2 <br /> <br />:xterior Walls <br />, Floors <br /> <br />:xter ior Walls <br />, Ceili ngs <br /> <br />luctWor k <br /> <br />~ i replaces <br /> <br />:xhaust Fans <br /> <br />606.1 <br /> <br />606.1 <br /> <br />606.1 <br /> <br />606.1 <br /> <br />606.1 <br /> <br />606.1 <br /> <br />606.1 <br /> <br />606.1 <br /> <br />606.1 <br /> <br />606.1 <br /> <br />COMPLY WITH ALL INFILTRATION PRESCRIPTIVES. <br /> <br />Maximum of 0.34 CFM per linear foot of operable sash <br />crack (includes sliding glass doors). <br /> <br />Maximum of 0.5 CFM per sq. ft. of door area: solid <br />core, wood panel,insulated or glass doors only. <br /> <br />To be caulked, gasketed, weather-stripped or other- <br />wise sealed. <br /> <br />COMPLY WITH PRACTICE #1 AND THE FOLLOWING: <br /> <br />Top plate penetrations sealed. Infiltration barrier <br />installed. Sole plate/floor joint caulked or sealed. <br /> <br />Penetrations, joints and cracks on interior surface <br />caulked, sealed or gasketed. <br /> <br />Ductwork in unconditioned space must be sealed. <br /> <br />Equipped with outside combustion air, doors and flue <br />dampers. <br /> <br />Equipped with dampers. Combustion devices see <br />606.1.A.2. <br /> <br />~---------------------------------------------------------------.--------------- <br /> <br />:ombustion <br />\ppl ia nces <br /> <br />606.1 <br /> <br />Be in unconditioned space (except direct vent), draw <br />air from unconditioned space, exhaust to outside. <br />Cooking appliances shall be dampered and use <br />intermittent ignition. <br /> <br />~---------------------------------------------------------------,--------------- <br /> <br />(* OTHER PRESCRIPTIVE MEASURES (must be met or exceeded by all residences.) ** <br /> <br />~--------------------------------------------------------------~,--------------- <br /> <br />Jater Heaters <br /> <br />612.1 <br /> <br />Comply with efficiency requirements in Table 6-12. <br />Switch or clearly marked circuit breaker (electric) <br />or cutoff (gas) must be provided. External or built- <br />in heat trap required. <br /> <br />~------------------------------------------------------------------------------- <br /> <br />;wimmi ng Pools <br />, Spas <br /> <br />612.1 <br /> <br />Spas and heated pools must have covers (except solar <br />heated). Non-commercial pools must have a pump timer. <br />Gas spa & pool heaters must have a minimum thermal <br />efficiency of 78 percent. <br /> <br />~---------------------------------------------------------------,--------------- <br /> <br />;hower Heads <br /> <br />612.1 <br /> <br />Water flow must be restricted to no more than 3 gal- <br />lons per minute at 80 PSIG. <br /> <br />~--------------------------------------------------------------_._---------~---- <br /> <br />WAC Duct <br />:onstruction <br />:nsulation & <br />:nstallation <br /> <br />WAC Controls <br /> <br />[nsulation <br /> <br />610.1 <br /> <br />607.1 <br /> <br />604.1 <br /> <br />All ducts, fittings, mechanical equipment and plenum <br />chambers shall be mechanically attached, sealed, ins- <br />ulated and installed in accordance with the criteria <br />of Section 610.1.ABC.2 & 610.1.ABC.3. Duct in attics <br />must be insulated to a minimum of R-6. Air handlers <br />shall not be installed in attics unless in mechanical <br />closet. <br /> <br />Separate readily accessible manual or automatic <br />thermostat for each system. <br /> <br />Ceilings minimum R-19. Common Walls - Frame R-11 or <br />