94-3986 - Laserfiche WebLink

Browse Search

r-'I'__~"._""""", " , '''''':'1..;J'-''';_''l''_.~-"""t.~",_.----,,~.~--..- -r~ l~ ~_.m7--' , ",..-(:-;;...,.,--~. since the ground pin on one of the plugs can make contact with this plate. This would corrupt the grounding network for the automatic scoring system. The recommended plastic plate for the Arrow Hart TVSS is an Arrow Hart P26 plate for a single outlet pair, an Arrow Hart P262 plate for a double outlat pair, or an Arrow Hart P264 plate for a quadruple outlet pair. Use no wire smaller than number 12 A WG, rated at 600 volts. Provisions must also be made to route the video and audio cables into the overhead area to the remote monitor housings. The com- mercial broadcast connections (Cable TV, Antenna, etc.) are the responsibility of the proprietor. The custome~s video equipment described above is not available through AMF. The proprietor is responsible for all connections required to hookup to the inputs of the audio preamplifiers and the video amp, which are a standard part of the installation. NOTE: The AudioNideo equipment described above will probably not exceed 7 amps @ 115V 50160 Hz or 4.2 amps @ 230V 50/60 Hz. 2.5.2 ADVANTAGE OR ADVANTAGE UTE FRONT DESK DEVICES The Advantage front desk equipment requires provisions at the control desk to locate the front' desk terminal, ticket printer, and lane interface unit. A three wire dedicated 115/230 volt 20 amp 50/60 Hz circuit with an isolate~ ground outlet, Arrow Hart IG5262S TVSS (Transient Voltage Surge Suppressor), with provisions for 4 plugs is required (an outlet strip may be used) and must be located within 4 feet of where the above equipment is to be installed. This isolated ground outlet should be covered with a plastic rather than a metal plate since the ground pin on one of the plugs can make contact with this plate. This would corrupt the ground- ing network for the automatic scoring system. The recommended plastic plate for the Arrow Hart TVSS is an Arrow Hart P26 plate for a single outlet pair, an Arrow Hart P262 plate for a double outlet pair, or an Arrow Hart P264 plate for a qua- druple outlet pair. This circuit shall not be connected to or used by any equipment other than the equipment described above. Use no wire smaller than number 12 A WG, rated 600 volts. Where length of circuit home run exceeds 100 feet use number 10 A WG for home run. Provisions must also be made to route the cables from this equipment to the back office equipment NOTE: The Front Desk Equipment described requires 4.5 amps @ 115V 50/60 Hz or 2.7 amps @ 230V 50/60 Hz. See appendix for Advantage configuration. ~ 2.5.3 ACCUDESK DEVltE;..O ,.. The AccuDesk front desk equipment requires provisions at the control desk to locate the AccuDesk chassis and interface box, front desk terminal, and ticket printer. A three wire dedicated 115/230 volt 20 amp 50/60 Hz Circuit with an isolated ground outlet, Arrow Hart IG5262S TVSS (Transient Voltage Surge Suppressor), with provisions for 4 plugs is required (an outlet strip may be used) and must be located within 4 feet of where the above equipment is to be installed. This isolated ground outlet should be covered with a plastic rather than a metal plate since the ground pin on one of the plugs can make contact with this plate. This would corrupt the grounding network for the automatic scoring system. The Page 5 Pre-lnstallation Requirements - 2000/3000 March 1993