95-4796 - Laserfiche WebLink

Browse Search

COMPONENTS' **. INFILTRATION.REDUC~ION PRACTICE COMPLIANCE CHECKLIST ** ~============================================================================== SECTION REQUIREMENTS FOR EACH PRACTICE CHECK =============================================================================== PRACTICE #1 606.1 COMPLY WITH ALL INFILTRATION PRESCRIPTIVES. ------------------------------------------------------------------------------- Windows 606.1 Maximum of 0.34 CFM per linear foot of operable sash crack (includes sliding glass doors). -------------------------------------------------------------------------------- Exterior & Adjacent Doors 606.1 Maximum of 0.5 CFM per sq. ft. of door area: solid core, wood panel,insulated or glass doors only. ------------------------------------------------------------------------------- Exterior Joints & Cracks 606.1 To be caulked, gasketed, weather-stripped or other- wise sealed. ---------------------------------------------------------------.---------------- PRACTICE #2 606.1 COMPLY WITH PRACTICE #1 AND THE FOLLOWING: ------------------------------------------------------------------------------- Exterior Walls ~ Floors 606.1 Top plate penetrations sealed. Infiltration barrier installed. Sole plate/floor joint caulked or sealed. ------------------------------------------------------------------------------- ~xterior Walls 1 Ceilings 606.1 Penetrations, joints and cracks on interior surface caulked, sealed or gasketed. ------------------------------------------------------------------------------- JuctWork 606.1 Ductwork in unconditioned space must be sealed. ..------------------------------------------------------------------------------ =ireplaces 606.1 Equipped with outside combustion air, doors and flue dampers. ------------------------------------------------------------------------------- :xhaust Fans 606.1 Equipped with dampers. Combustion devices see 606.1.A.2. ------------------------------------------------------------------------------- .ombustion ~ppliances 606.1 Be in unconditioned space (except direct vent), draw air from unconditioned space, exhaust to outside. Cooking appliances shall be dampered and use intermittent ignition. .------------------------------------------------------------------------------ =* OTHER PRESCRIPTIVE MEASURES (must be met or exceeded by all residences.) ** -------------------------------------------------------------------------------- Jater Heaters 612.1 Comply with efficiency requirements in Table 6-12. Switch or clearly marked circuit breaker (electric) or cutoff (gas) must be provided. External or built- in heat trap required. .-------------------------------------------------------------------------------- .wimming Pools Spas 612.1 Spas and heated pools must have covers (except solar heated). Non-commercial pools must have a pump timer. Gas spa & pool heaters must have a minimum thermal efficiency of 78 percent. hower Heads ------------------------------------------------------------------------------- 612.1 --~--------------------------------------------------------------------------- Water flow must be restricted to no more than 3 gal- lons per minute at 80 PSIG. VAC Duct onstruction nsulation & nstallation 610.1 All ducts, fittings, mechanical equipment and plenum chambers shall be mechanically attached, sealed. ins- ulated and installed in accordance with the criteria of Section 610.1.ABC.2 ~ 610.1.ABC.3. Duct in attics must be insulated to a minimum of R-6. Air handlers shall not be installed in attics unless in mechanical closet. ------------------------------------------------------------------------------ VAC Controls 607.1 --------------------------------------------------------------_._-----~-------- Separate readily accessible manual or automatic thermostat for each system. nsulation 604.1 602.1 Ceilings minimum P-19. Common Walls - Frame P-11 or CBS R-3 both sides. Common ceiling & floors R-l1.