95-4866 - Laserfiche WebLink

Browse Search

*~ IN~ILTRAT~ON. ~EDUCTION PRACTICE COMPLIANCE CHECKLIST ** , ~=~==~====~===================================================================== ~OMPONENTS SECTION REQUIREMENTS FOR EACH PRACTICE CHECK =========================================~====================================== )RACTICE #1 606.1 COMPLY WITH ALL INFILTRATION PRESCRIPTIVES. --------------------------~----------------------------------------------------- J i ndows 606.1 Maximum of 0.34 CFM per linear foot of operable sash crack (includes sliding glass doors). ~------------------------------------------------------------------------------- ~xterior & ~djacent Doors 606.1 Maximum of 0.5 CFM per sq. ft. of door area: solid core, wood panel,insulated or glass doors only. ------------------------------------------------------------------------------- ~xter ior Joi nts , Cracks 606.1 To be caulked, gasketed, weather-stripped or other- wise sealed. ------------------------------------------------------------------------------- )RACTICE #2 606.1 COMPLY WITH PRACTICE #1 AND THE FOLLOWING: ~---------------------------------------------------------------.--------------- : xter i or Walls , Floors 606.1 Top plate penetrations sealed. Infiltration barrier installed. Sole plate/floor Joint caulked or sealed. .------------------------------------------------------------------------------ 'xter ior Wal is , Ce i 1 i ngs 606.1 Penetrations, joints and cracks on interior surface caulked, sealed or gasketed. --------------------------------------------------------------------------~----- 'uctl,..Jor k 606.1 Ductwork in unconditioned space must be sealed. ireplaces .------------------------------------------------------------------------------ 606.1 Equipped with outside combustion air, doors and flue dampers. xhaust Fans ------------------------------------------------------------------------------ Equipped with dampers. Combustion devices see 606.1.A.2. 606.1 ombustion ppliances ------------------------------------------------------------------------------ 606.1 Be in unconditioned space (except direct vent), draw air from unconditioned space, exhaust to outside. Cooking appliances shall be dampered and use intermittent ignition. ----------------------------~-------------------------------------------------- * OTHER PRESCRIPTIVE MEASURES (must be met or exceeded by all residences.) ** ------------------------------------------------------------------------------ ater Heaters 612.1 Comply with efficiency requirements in Table 6-12. Switch or clearly marked circuit breaker (electric) or cutoff (gas) must be provided. External or built- in heat trap required. ---------------------------------------------------------------.---------------- wimming Pools Spas 612.1 Spas and heated pools must have covers (except solar heated). Non-commercial pools must have a pump timer. Gas spa & pool heaters must have a minimum thermal efficiency of 78 percent. ------------------------------------------------------------------------------ ,ower Heads 612.1 Water flow must be restricted to no more than 3 gal- lons per minute at 80 PSIG. --~--------------------------------------------------------------------------- lAC Duct )nstruction isulation & lstallation 610.1 All ducts, fittings, mechanical equipment and plenum chambers shall be mechanically attached, sealed, ins- ulated and installed in accordance with the criteria of Section 610.1 .ABC.2 ~ 610.1.ABC.3. Duct in attics must be insulated to a minimum of R-6. Air handlers shall not be installed in attics unless in mechanical closet. ------------------------------------------------------------------------------ lAC Controls 607.1 ----------------------------------------------------------------.-------------- Separate readily accessible manual or automatic thermostat for each system. lsulation 604.1 602.1 Ceilings minimum R-19. Common Walls - Frame R-l1 or CBS R-3 both sides. Common ceiling & floors R-11.