96-6215 - Laserfiche WebLink

Browse Search

10/24/1996 10:51 3525676111 SO COMFORT ENT I~: PAGE 03 ** INFILTRATION REDUCTION PRACTICE COMPLIANCE CHECKLIST ** S_5~_~--S--=-=--~==~==~==-~=_~=_=5~=-C=_=5~=-~~-=sm=~=~s=~~=_==-=~c~-==~=-~=-=~ COMP~Ni;TS- - --SECTION REQUIREMENTS FOR EACH PRACTICE CHECK ~~~==$=======~==~~==~5=~~~=5~=5==_C=_=~_=5C=-C===~==~~=_==_=~==-==-======5==5== PRACTICE *1 606.1 COMPLY WITH ALL INFILTRATION PRESCRIPTIVES. ------------------------------------------------------------------------------- Windows 606.1 Maximum ot 0.34 CFM per linear toot of operable sash crack (includea sliding glasa doors). ------------------------------------------------------------------------------- Exterior & Adjacent Doors 606.1 Maximum of 0.5 CFM per sq, ft. of door area: solid core, wood panel, insulated or glass doors only. --------------------------------------------------------------.----------------- Exterior Joints & Cracks 606,1 To be caulked, gasketed, weather-stripped or other- wise sealed. --------------------------------------------------------------.----------------- ** OTHER PRESCRIPTIVE MEASURES (must be met or exceeded by all residences.) ** ------------------------------------------------------------------------------- Water Heaters 612,1 Comply with efficiency requirements in Table 6-12. Switch or clearly marked circuit breaker (electric) or cutoff (gas) must be provided. External or built- in heat trap required. ------------------------------------------------------------------------------- swimming Pools & Spas 612,1 Spas and heated pools must have covers (except solar heated), Non-commercial pools must have a pump timer, Gas spa & pool heaters must have a minimum thermal efficiency of 78 percent. ------------------------------------------------------------------------------- Shower Heads 612,1 Water flo~ must be restricted to no more than 3 gal- lons per minute at 80 PSIG. ------------------------------------------------------------------------------- HVAC Duct Construction Insulation & Installation 610.1 All ducts, fittinga, mechanical equipment and plenum chamberB shall be mechanically attached, sealed, ins- ulated and installed in accordance with the criteria of Section 610.1.ABC.2 & 610.1.ABC.3. Duct in attic8 must be insulated to a minimum of R-6, Air handlers shall not be installed in attics unless in mechanical closet. ---------------------- - HVAC controls 607.~-- ~~~~;~~~-;~~~ii;-~~~~~~i~~:-~~~~~~-~~-:~~~~:~i~------ thermostat for each system, -------------------- Insulation 60~~1---;~i~~~~;-~i~i;~~-;:19~-~~~~~-;~ii~-=-;~~;~-;:11-~~-- 602,1 CBS R-3 both sides. Common ceiling & floors R-l1. -------------------------------------------------------------------------------