01-0615 - Laserfiche WebLink

Browse Search

ASSEMBL Y (Cont'd) GENERAL , 1. After determining the size and type of your booth to be employed. ensure that an assembly site is available that meetS the following qualifications: A, A minimum of three feet at sides of the booth must be clear and free from storage of combustible consttuction or other operations. A minimum ofthrec: feet clearance is required in front of the booth opening, with si.'t feet or more from the nearest wall preferred from the standpoint of providing smoother air flow through the booth. B. The floor surface oftbe booth and operator's working area must be non-combustible material such as to facilitate the safe cleaning and removal of residues, It must be able to suppOrt tlte weight oCthe booth and the operator. C. The floor surface of the booth must be flat and level to avoid erection problems 10 alignmem of panels, etC. Shims should be used if necessary. 2. Using chalk, mark the dimensional outline of the booth on the floor. Check ceiling beight for ample clear.mce. Check exhaust outlet location with the roof or wall to avoid obstructions in the line of the exhaust pipe. 3. Unpaclc all components and stack all parts oflhe same size together. Each compone:Jt IS identifiable by a size description listed on view drawing, 4. Using the size description on drawings. ensure that aU spray booth components are at hand. 5. Study all the drawings and instructions thoroughly before beginning assembly. Each COIDpOIlCJIt is shown by parr letter or number on the assembly drawings. This will aid in determining where the various components are to be installed during assembly. 6. Assemble the booth using the assembly drawing. (Always start with the exhaust chamber section.) 7. Mowlt emau:it unit and motOr. Exhaust Unit - ensure that there are no obsttuctions in the unit that would dama2C it. Make cenain that electrical connections have been made properly and thai direction of rotation is as indicated. Start exhaust unit. 8. Install exhaust piping. Where oore than 25' of piping is required, the static pressure is increased in thai air flow may be hindered when using the standard exhaust unit recommended for use with the booth. \\'here a piping arrangement of an unusual nature tS employed or where two or more elbows are used. a similar condition my exit. Therefore, if either of these situations arise, contact your local distributor or the manufacturer for correct recommendations. 9. Instaillighting fixtures.