Laserfiche WebLink
<br />1l0.26(A)(2): <br /> <br />110.26(A)(3): <br /> <br />210.8(A): <br /> <br />210. 11 (C)(3): <br /> <br />250.50: <br /> <br />250.66: <br /> <br />EiectricaJ Notes <br />2002 Electrical Code <br />M. Scott Meyer <br />5411- 10th St.. <br /> <br />The width of the working space in front of the electric equipment shall be the width of <br />the equipment or 750 mm (30 in.), whichever is greater. In all cases, the work space shall <br />permit at least a 90 degree opening of equipment doors or hinged panels. <br /> <br />The work space shall be clear and extend from the grade, floor, or platform to the height <br />required by 110.26(E). Within the height requirements of this section, other equipment <br />that is associated with the electrical installation and is located above or below the <br />electrical equipment shall be permitted to extend not more than 150 mm (6 in.) beyond <br />the front of the electrical equipment. <br /> <br />All 125-volt, single-phase, 15- and 20-ampere receptacles installed in the locations <br />specified in (I) through (8) shall have ground-fault circuit-interrupter protection for <br />personnel. <br /> <br />(l) Bathrooms <br /> <br />(2) Garages <br /> <br />In addition to the number of branch circuits required by other parts of this section, at least <br />one 20-ampere branch circuit shall be provided to supply the bathroom receptacle <br />outlet(s). Such circuits shall have no other outlets. <br /> <br />Exception: Where the 20-ampere circuit supplies a single bathroom, outlets for other <br />equipment within the same bathroom shall be permitted to be supplied in accordance <br />with 210. 23(A). <br /> <br />If available on the premises at each building or structure served, each item in <br />250.52(A)(1) through (A)(6) shall be bonded together to form the grounding electrode <br />system <br /> <br />Grounding electrode conductor shall be sized according to Table 250.66 <br /> <br />10i 20"'03 <br />2:25 ,"M <br />