Laserfiche WebLink
<br />GEH 12 or 24 Volt Low Profile Evacuation Horn <br /> <br /> <br />GES312 or 24 Volt Selectable Candela Low Profile Evacuation Strobe <br /> <br /> <br />Model deslanatlons: <br />"W" = Wall Mount <br />"RU = Red Faceplate <br />"W" = Off-White Faceplate <br />"P" = Plain (no lettering) Available <br />with all models. <br />These units are non-returnable. <br />"Agent" bezel also available. <br /> <br />GEC3 12 or 24 Volt Selectable Candela Low Profile Evacuation Horn/Strobe <br /> <br /> <br />Notes: <br />. The GE3 Series is not listed for outdoor use. . Operating temperature: 32"10 1200F (00 to 490 C). <br />. For nominal and peak current across UL regulated voltage range for filtered DC power and unfiltered <br />(FWR [Full Wave Rectified)) power, see installation manual. 12 volt models are DC only. <br />. Gentex does not recommend using a coded or pulsing signaling circuit with any of our strobe products <br />(see Technical Bulletin Number 014). <br /> <br />r uct tra e urrent <br /> <br />oop oop <br /> <br />'Operating the horn in this mode at this vo~age will result in not meeting the minimum UL reverberant sound level required for public mode fire protection selVice. These set- <br />tings are acceptable only for private mode fire alarm use. Use the high dBA setting for public mode application (not applicable when using the chime tone, The chime tone is <br />always private mode). <br />Notes: The sound output for the temporal 3 tone is rated lower since the time the horn is off is averaged into the sound output rating. While the horn is producing a tone in <br />the temporal 3 mode its sound pressure is the same as the continuous mode, <br /> <br />To obtain the horn/strobe current draw, add the strobe current draw and the horn current draw. <br /> <br /> <br />egu <br />12VDC Max. <br />Operating @ <br />High Setting (mA) <br /> <br /> <br />egu e <br />24VDC Max. <br />Operating @ <br />High Setting (mAl <br /> <br />1 The listed reverberant dBA are for the Continuous Tone mode. The Temporal 3 Tone has a reverberent dBA @ 1011. per UL 464 Is 77-83 wnh a horn current draw of 34mA. <br /> <br />2 RMS current ratings are per UL average RMS method. UL max current rating Is the maximum RMS current wfthln the listed voltage range (16-33VOC for 24VDC units) (B-17VDC for <br />12VDC units). For strobes the UL max current Is usually at the minimum listed vonage (16VDC for 24VDC unns) (BVDC for 12VDC unns). For audibles the max current is usually at the <br />maximum listed voltage. For unflnered FWR ratings, see Installation manual. <br />