Laserfiche WebLink
<br />. 8 'I~T RIOR FINISHING <br /> <br />Visible wood s rfaces of Pella. products must be finished. FaihA'e to do so voids the Limited Warranty, If products cannot be finished <br />immediately, c vel' with clear plastic to protect from dirt, daAtage and moisture. Remove any construction residue before finishing. Sand all <br />wood surfaces I ghtly with 180 grit or finer sandpaper. DO NOT use steel wool. BE CAREFUL NOT TO SCRATCH THE GLASS. <br />Remove sandi dust, <br /> <br />For additional formation on finishing see the Pel1a Owner's Manual or www.pe1Ja.com. <br /> <br />Note: 10 main 'a1n proper product performance do not paint, Dnish or IY!lDOJlf! the weatber-strJpplng, gaskets or vinyl parts. Air and <br />water leakage result if these parts are removed. Aber DnlshJng, aUow doors to dry completely befon dosing them. <br /> <br />Pella Corporati n is not responsible for finishing imperfections. Use of inappropriate finishes, solvents, brickwash or cleaning chemicals will <br />cause adverse ctions with window and door materials and voids the Limited Warranty. <br /> <br />EXTERI <br /> <br /> <br />The exterior fr e and sash are protected by aluminum cladding with our tough EnduraClad" or EnduraClad PIus baked-on factory finish that needs <br />no painting. Cle this surface with mild soap and water. Stubborn stains and deposits may be removed with mineral spirits. DO NOT use abrasives, <br />DO NOT scrap or use tools that might damage the surface, <br /> <br />Use of inapprop ate finishes. solvents, brickwash or cleaning chemicals will cause adverse reactions with window and door materials and voids the <br />Limited Warran <br /> <br />D MAINTENANCE <br /> <br />Care and mainte ance information is available in the Pella Owner's Manuai, You can obtain an owner's manual by contacting your local Pella retailer. <br />This informatio is also available on www.peJJa.com. <br /> <br /> <br />NOTE <br /> <br />Because all cons ction must anticipate some water infiltration, it is important that the wall system be designed and constructed to properly manage <br />moisture, Pella C rporation is not responsible for claims or damages caused by unanticipated water infiltration; deficiencies in building design, <br />construction and aintenance; failure to install Pella products in accordance with these instructions; or the use of Pella products in systems which <br />do not allow for roper management of moisture within the wall systems, The determination of the suitability of all building components, including <br />the use of Pella p ducts, as well as the design and installation of flashing and sealing systems are the responsibility of you, your architect, or a <br />construction profi ssiona!. Moisture problems, including unacceptable water infiltration, have been associated with barrier systems, such as EIFS <br />(also known as s thetic stucco), Pella products should not be used in barrier EIFS systems unless Pella's current, recommended installation <br />procedures for i ation of windows and doors into EIFS are used, Any other use of Pella products with barrier EIFS systems will void the <br />Limited Warran <br /> <br />Product modifica ons that are not approved by Pella Corporation will void the Limited Warranty, <br /> <br />@Pel1a Corporati 2004 <br /> <br />Part Number: 801W0005 <br />