Laserfiche WebLink
<br />07033 <br /> <br />Addressable Fire System Controller <br /> <br />. <br />Specifications <br /> <br />Features <br /> <br />. Addressable Fare System Controller <br /> <br />. Compatible with the 07024 Fire Alarm Controll <br />Communicator <br /> <br />. Two-line, 32-character, alphanumeric LCD display <br /> <br />. Status LEOs identify AIann, Trouble, Power and Silenced <br />conditions <br /> <br />. Address setting by jumper <br /> <br />. Permits remote control d system, including commands and <br />programming <br /> <br />. Passcode protection controls system access <br /> <br />. Low profile design <br /> <br />Description <br /> <br />The Radionics 07033 Are System Controller combines fire <br />system annunciator and controller functions. It operates <br />identically to the built-in user interface on the 07024 Fire Alarm <br />Control/Communicator. Up to four 07033 controllers may be <br />connected to a 07024. <br /> <br />Placing jumpers on the address 'pins sets the controller address. <br /> <br />The 07033 allows remote initiation of local system tests, system <br />programming and system control, as well as remote viewing of <br />the system's event log. Access to system functions can be <br />passcode protected. <br /> <br />The two-line, 32-character LCD display annunciates system <br />status and events. The top line provides general system status <br />information, while the bottom line identifies specific devices or <br />procedures. <br /> <br />An internal sounder signals alarm and trouble conditions, and <br />annunciates keystrokes during programming and control <br />procedures. <br /> <br />Four status LEOs indicate power, alarm, trouble and silenced <br />conditions. <br /> <br />A pullout slide with operating instructions fits behind the <br />mounting base. <br /> <br /> <br />r I 2 n~) <br />,_;L 6) <br />(n.~_ \ Ill' .9J <br /> <br />~ <br /> <br /> <br />}~}~'i>"~',:"; <br />~ii:: <br /> <br />,.-. <br /> <br />D7033 Addressable Fire System Controller <br /> <br />Application <br /> <br />The 07033 Fire System Controller combines remote <br />annunciator and controller functions for fire alarm systems <br />controlled by the 07024 Fire Alarm Control/Communicator. <br />Access to control functions is passcode protected, allowing <br />installation in areas open to the general public. <br /> <br />Installation <br /> <br />The 07033 is a low profile unit that may be surface-mounted or <br />mounted to a single gang, double gang, or 4 inch square back <br />box. <br /> <br />The control panel connection to the controller is through four wires <br />teminaling at the controller's terminal strip. Two wires are reserved <br />for paneI-to-controler communication; the other two wires are used <br />to supply 12 VOC power. <br /> <br />Refer to the control panel's installation guide for detailed wiring <br />length information. <br /> <br />Install, test, and maintain this device accorcling to its Installation <br />Guide, NFPA 72, Local Codes and the Authority Having <br />Jurisdiction. Failure to follow these procedures may result in <br />failure of the device to operate properly. Radionics is not <br />responsible for devices that are improperly installed, tested or <br />maintained. <br /> <br />$ radionics <br /> <br />A member of the <br />Bosch Group <br />