Laserfiche WebLink
OS- 1 1 21709 t ! 1 H[IE:I L E HOME SI IF'F'L 'i 86" <br /> F'F -IGE <br /> • Revistod Jas. 20, 2906 <br /> Recommended Window Installation Instructions <br /> For Metal, Vinyl, Flush Mount and Recessed Fin <br /> Including Egress Units <br /> MANUFACTURERS NOTE: Failure to follow these instractioas may rause the window trot to function properly. All <br /> product liability and warranty conk' he void. These installation inNrsctions are recommendations only. Local building <br /> codes may impose additional requiremr:ats, and those codes may supersede these instructions. <br /> Roush Opening Preparation <br /> A. Opening for windows should be framed in accordance with the required standards for sine of window <br /> used in order not to apply any loading to the window which may hamper its operation. The prepared <br /> rough opening should allow 1/8" clearance on each side, the head and the sill, including the thickness of <br /> pre - finished paneling, shims, liners, etc., where used. <br /> B. Window roach openinr should be level. plumb and square: Check width, height, and diagonal <br /> measurements for squareness. There should be no more than 1/8" variation between these <br /> measurements. Avoid the use of warped, twisted, or knotted framing members. It is recommended <br /> that the sill of the rough opening be straight and IeveL Bowed or warped sill homing members <br /> can result do a crowned sill of the window. <br /> C. Make certain all mounting surfaces (siding included) are securely fastened and flat around the perimeter <br /> of the window opening. Check the opening for correct size. Kinro recommends adding 1/4" to the <br /> actual window width and 1/4" to the actual window height for the rough opening size. <br /> D. According to Federal Manufactured Home Construction and Safety Standard, the bottom of an Egress <br /> window shall not exceed 36 inches above the floor, nor shad] any latch or other device for the window, <br /> screen, or storm window which needs to be operated in order to permit exiting, be located in excess of <br /> 44 inches from the finished floor. <br /> E. Flashing: It is not the responsibility of the window manufacturer to design or recommend a flashing <br /> system appropriate to each job condition. <br /> 11. Window Installation <br /> A. It is recommended to apply a 1/8" thick, suitable, good quality, non- hardening, water resistant sealant <br /> tape (putty or butyl type) to the back of the window mounting flanges in order to provide a good seal <br /> with the homes weather -proof envelope. If a gunable sealant is used, a 1/4" bead should be applied <br /> centered over the mounting holes on the back of the window mounting flange. <br /> CAUTION: <br /> • For vinyl windows, do not we a sealant that contains solvents which may chemically attack <br /> vinyl. <br /> • The use of foam tapes is not recommended for window installation. <br /> B. 1)o not remove any shipping clips (if provided on the window series being installed) and always keen <br /> operating sash closed and locked during installation. <br /> I 1 , <br />