09-9908 - Laserfiche WebLink

Browse Search

-0?- ] ] - 2O09 g q : K FJ J MOBILE HOME SUPRA BE.-. , 7 3' F'AGE : 7 C. Always handle windows properly. Always pick them up by both side jambs using both hands. Never pick up and handle windows by the header only, sill only, or by one side jamb only. This can damage the windows and possibly rupture the glazing seal and/or joint caulking, thus resulting in a possible leak D. Carefully insert the window into the opening. Center the window in the rough opening with the sill of the window resting on the sill of the rough opening. E. Drive the first fastener at approximately the center of the vertical frame jamb. Drive the second fastener on the opposite jamb at the approximate center. Drive the third fastener at the center of the sill member_ (Note: When installing windows check the window sill for straightness. lithe window sill is crowned, apply light pressure at the center of window sill until it is level. While holding the sill level, drive the third fastener into the center of the sill.) Drive the fourth fastener at the center of the head. Run fasteners, from one of the above fasteners, to the end of each frame member). Repeat this step until all fasteners have bccn inserted from the center of the vertical frame jamb outward to both ends of each member. Finish installing the fasteners from the center of the Frame Head and Sill outward to the ends of each member. See attached drawing for visual guide to fastener placement of assorted window types. Note: All fasteners should be driven straight into the window fralne. See section ID for fastener information. This sequence of fastener installation applies to both vertical and horizontal sliding windows, flush mount and recessed fin mount, for both metal and vinyl windows. A drawing is attached for visual reference. After the initial fasteners are placed, it is important that the installer does not run the remainder of the fasteners in a continuous clockwise (or counter clockwise) fashion around the window. F. Avoid damage to the seal between the glass and the window glazing member. Power drivers should be adjusted so as not to cause excessive dimpling of the window flanges. Careless mounting procedures could negate window certification - 0. if the exposed surfaces of the rough inside opening are to be trimmed out with pre - finished paneling, it must be done in such a manner so as not to distort or twist the window frame members and make the operating sash tight or inoperable. if interior trim is installed prior to window installation insure that enough room is left to allow the window to fully seat against the exterior wall surface. Do not obstruct tilting sash operation or locking mechanisms with inside trim, wood molding, etc. II. Windows should be checked after installation to make sure that all moving panels, mechanisms, latches, and other hardware function properly. Any shipping clips must be removed prior to operation of the window. I. The window's exterior mounting flanges should be checked after the installation to assure an all- weather seal. It is recommended to seal the outside top of window (full width) with a good quality sealant for additional insurance. J. For vinyl windows, leave an appropriate gap between the edge of the siding material and the window frame to allow for siding expansion and contraction. For large vinyl windows with recessed fms (size 72" in width and wider) Kinro recommends a sill support (minimum I" thick) be installed underneath the projected frame sill on the outside.