09-9146 - Laserfiche WebLink

Browse Search

05- 20 -'09 09: 00 FROM -ABC SUPPLY CO. 3525232227 T -850 P0081011 F -037 SY'SThM A 2S: "W" 26 Ga. Metal Panel Deck Type: Wood, Non - insulated Deck Description: 19 42" or greater plywood or wood plank. Slope Range: 2 ": 12" or greater Maximum Uplift The maximum allowable design pressure for the 24" wide panel Pressure: shall be 420.9 psf. (See General Limitation #1) Deck Attachment: In accordance with applicable Building Code, but in no case shall it be less than #8 x 2" wood screws spaced 6" o.c around the perimeter and 12" o.c. in the field.. In reroofing, where the deck is less than 14 !32" thick (Minimum 15 /32') The above attachment method must be in addition to existing attachment. Underlayment: Minimum underlaytnent shall be a ASTM D 226 Type II installed with a minimum 4" side -laps and 6" end -laps. Underlayment shall be fastened with corrosion resistant tin -caps and 1A" annular ring -shank nails, spaced 6" o.c. at all laps and two staggered rows 12" o.c. in the field of the roll. Valleys: Valley construction shall be in compliance with Roofing Application Standard RAS 133 and with Union Corrugating Company's current published installation instructions. Fire Barrier Board: For class A or B fire rating, install minimum 1/4" thick Georgia Pacific "Dens Deck" (with current NOA) or minimum 4mm thick of Tritex, Rockiioof (with current NOA) or 5 /g" water resistant type X gypsum sheathing with treated core and facer or Elk Versashield (with current NOA). Metal Panels and Install. the "SV Steel Roofing Panel" and accessories in compliance with Accessories: Union Corrugating Company's current published installation instructions and details. Hashing, penetrations, valley construction and other details shall be constructed in compliance with the minimum requirements provided in Roofing Application Standards RAS 133. SV Roofing Panels shall be fastened with a minimum of #9 Hex Head Wood corrosion resistant fasteners with sealing washer. Fasteners shall of sufficient length to penetrate through the sheathing a minimum of 3 46 ". Fasteners shall be place in accordance with fastener detail herein as follows: 3. Panel side ribs shall be fastened along side of the panel inside ribs, one fastener at the overlap and one fastener at the underlap. Center panel rib shall be fastened with one fastener at the overlap side of the panel. 4. All fasteners at center rib, underlap rib, and overlap rib shall be spaced at a maximum of 24 inches o.c. parallel to the roof slope. See Detail B herein. NOA No.: 06- 1002.13 Expiration Date: 06/17/12 Approval Date: 06/14/07 Page 4of7