Laserfiche WebLink
G310A -A <br /> Page 14 Revised February 20, 2007 <br /> SYSTEM INSTALLATION INSTRUCTIONS (Cont'd) <br /> 9. Place the magnetic based discharge hose / <br /> nozzle assembly underneath the range hood, i.e., <br /> one magnet base in each side of the range hood VIEW INSIDE BOTTOM OF HOOD <br /> routing the stainless steel braided hose around {REAR WALL) <br /> obstacles. Slack in the hose is permissible. Burner Centerline <br /> Magnetic force will hold the discharge hose 1 <br /> nozzle assembly underneath the range hood. <br /> Refer to Pages 14 and 15 (FIGURE 23 & 24) for <br /> proper placement. Min Max ; <br /> 10" <br /> Magnet o u se Max t <br /> Sensor ��0 <br /> �� Nozzle �e G <br /> • I t io 2" Only occ: <br /> Positioning t ; <br /> • Centerline <br /> Temperature of Magnetic Projentad Conter Fne — <br /> Distribution "L" Sensor Nozzle Base of Burners <br /> Hose COI <br /> Nozzle 1611 (From) <br /> 36" Max (Gas Stove) <br /> 42" Max (Electric Stove) <br /> 11Sil <br /> FIGURE 22 mom FIGURE 23 <br /> NOTE: The nozzle openings must be facing <br /> towards the stove top. Insure magnet bases are <br /> not in a cocked position, i.e., are not being held <br /> securely to the range hood. <br /> Extend the stainless steel braided hose from the 11. To place sensor 2 metal housing on the other <br /> extinguisher cylinder assembly through the 7/8" hole. magnetic based nozzle assembly, repeat <br /> Hook the quick connect hose fitting to the discharge procedure in step 10. <br /> hose /nozzle assembly at the Tee Fitting. <br /> 12. Hook up sensor wires according to FIGURE 3 <br /> 10. Place sensor 1 metal housing against the side of Page 5. Use wire strain relief on enclosure circuit <br /> the magnetic base of the nozzle assembly. board frame to hold sensor wires in place. <br /> Magnetic force will hold sensor housing to <br /> magnetic base. The sensor diodes must be <br /> facing towards the stove top with open side of <br /> sensor housing facing up and against the range <br /> hood. Carefully wrap the sensor wires around the <br /> braided hose while inserting through the 7/8" <br /> hole. Insure sensor housing / sensor diodes are <br /> parallel with the stove top, with sensor diodes <br /> facing the stove top and sensor housing is being <br /> held securely to the magnetic base, i.e., sensor <br /> housing is not in a cocked position. Position the <br /> magnetic nozzle / sensor base inside the exhaust <br /> hood, as referenced in FIGURE 22 and aim the <br /> nozzles, as outlined on Page 15 (FIGURE 25). <br />