10-10233 - Laserfiche WebLink

Browse Search

G310A -A Page 16 Revised February 20, 2007 SYSTEM CHECK OUT SYSTEM CHECK -OUT AFTER INSTALLATION Use a wire and create a short across one of the sensor terminals (P1 -1 & 2 or P1 -3 & 4). CAUTION: To avoid accidental discharge "DO NOT REMOVE PULL PIN" at this time IMPORTANT: REMAIN SHORTED FOR 20 - 30 Refer to Page 17, FIGURE 26 for this step AFTER SECONDS. system and shutoff check-out. 1. Verify that the release valve solenoid is activated. After aiming the spray nozzles and placement of the (See FIGURE 26) temperature sensors conduct final system check -out to include operation of the electric or gas shutoff by 2. After 20 — 30 seconds, remove the short across the accomplishing the following: sensor terminals. System alarm continues (Fire Detect Mode Disabled). Push K1 switch near LED 1. Insure the 9V DC battery is installed in the central on Main CPU board for Piezo alarm reset. (See FIGURE 3 ) processing unit (CPU) board. 2. If the alarm sounds, remove the battery 3. Verify that the electric or gas shutoff has been immediately and recheck the connections as activated by observing the test results. shown in FIGURE 3 for one or more of the See "TEST RESULTS" below. following: A. Open or bad connection to the sensors SONIC RECEIVER TEST PROCEDURES B. Shorted sensor or frayed wires shorting. C. Open or bad connection to the electronic release valve. (IF THE INTERCONNECT CABLE IS USED GO TO 3. In the event of a low battery, the alarm will "chirp" "INTERCONNECT TEST PROCEDURES ") approximately once every 45 seconds. The unit is still operational, but the battery must be replaced to Insure the electric or gas shutoff has been installed in assure continued, uninterrupted operation. accordance with the instruction contained in this manual. See Page 10 for Electric Range and Page 11 SHUTOFF CHECK -OUT & 12 for Gas Range. See page 8 for Sonic Receiver details. INTERCONNECT CABLE TEST PROCEDURES Perform the following: (IF OPTIONAL SONIC RECEIVER IS USED GO TO "SONIC RECEIVER" TEST PROCEDURES) Sonic Receiver: Install unit and plug into shutoff. Verify that LED "Power On" light is on. Insure the electric or gas shutoff has been installed in accordance with the instruction contained in this Electric Stove: Turn on any burner to the high manual. See Page 9 &10 for Electric Range and Page position until burner coil is hot. 11 & 12 for Gas Range. For Gas Stove: Light any burner and turn to the Perform the following: high position. Electric Stove: Turn on any burner to the high 1. Locate and remove the positive ( +) #2 heat sensor position until burner coil is hot. terminal wire connection (red lug) on the central processing unit control board terminal block. SEE For Gas Stove: Light any burner and turn to the FIGURE 3. high position. 2. Once removed, the audible Piezo Alarm on the Main CPU control board will activate. Note: DO NOT REMOVE a sensor wire. This NOTE: "Fail Safe Mode" is initiated. Though the enables the "FAIL SAFE" mode. Sensor audible alarm has activated, extinguisher cylinder must have a short across the terminals to release valve will not activate. simulate a "FIRE DETECT MODE ". 3. Allow Main CPU board audible alarm to sound for approximately 20 -30 seconds, which will activate either the electric or gas shutoff via the Sonic Receiver board.