Laserfiche WebLink
AES 7788 Set ies RF Srrbsrribei (/nit — Installation and Open aeon Manual <br /> 3 Installation <br /> This section contains information on the installation and wiring of the AES IntelliNet <br /> 7788F RF Subscriber Unit. <br /> For Fire applications this product must be connected to a Fire panel that provides <br /> system status changes on a system wide basis for Alarm, Trouble and Supervisory at <br /> a minimum. <br /> 3.1 Overview <br /> The AES 7788F combines the electronics of an AES Subscriber unit, battery, a radio <br /> transceiver and any approved modules such as the 7770 or 7067 into its enclosure. It <br /> is typically used to communicate alarm and status conditions of an alarm panel to a <br /> centrally located alarm monitoring facility via radio transmissions. A properly <br /> powered and configured AES 7788F will communicate with an AES Central Receiver <br /> via a locally provided AES IntelliNet Network. <br /> 3.2 Physical Installation <br /> Installation Guidelines. Refer to Diagrams throughout this document for typical <br /> component installation locations. <br /> • To comply with UL 365 Section 44, all wiring except the AC must use shielded <br /> wires At least one end of the shield must be grounded, <br /> • Choose an indoor climate controlled, secure, and dry location for the subscriber <br /> unit's installation. <br /> ♦ Avoid extremes of heat, cold, humidity, dust. Refer to range listed in <br /> specification section of this document. <br /> ♦ Mount enclosure to a suitable, strong surface using appropriate fasteners for the <br /> weight of the unit and the surface on which it is being installed. <br /> • Pre -cut "knockout" type holes are provided on the back and sides of the case for <br /> wiring access. Knockouts are sized for standard 1/2 inch conduit connectors. <br /> ♦ For burglar applications, the unit should be located away from the alarm panel — <br /> hidden if possible — and within the protected area. This will aid in the successful <br /> communication of the intrusion even if the alarm panel is compromised. <br /> ♦ The supplied case top tamper resistant Flexible 2.5db antenna is mounted on the <br /> Subscriber's enclosure as shown in diagram 2 in this document. <br /> ♦ A remote external antenna can also be purchased separately and installed. <br /> Refer to Section L9 for information on some available from AES. <br /> ♦ A remote antenna should be mounted in a location near the transceiver to <br /> minimize inherent signal loss due to unnecessary cable length. Do not use longer <br /> coax than is needed to reach the antenna. <br /> ♦ Mount antenna as high as possible, on or in the structure, with attics and rooftop <br /> locations preferred. Height need not be higher than is required to overcome <br /> nearby obstructions to the signal path if any additional height would use a longer <br /> coax length <br /> AES Corporation // 40 -7788. Re;' 3a. 4/9/2009 <br />