Laserfiche WebLink
• <br /> Chapter 3 — System Design <br /> Page 3 -13 <br /> REV. 2 <br /> 14. Chain Broiler (internal chamber 1026 sq. In. <br /> (6619 sq. cm) x 38 in. (97 cm) longest side maximum) 15. Tilt Skillet/Braising Pan <br /> Protection for tilt skillet or braising pans is to be based <br /> One nozzle Is available for chain broiler protection. <br /> The 1L nozzle, Part No. 551026, is used for broiler protection. Coverage Iim based on fryer sizes <br /> protection. This nozzle is a one (1) flow nozzle. The Including drip boards. Exception: Tilt skillets and braising <br /> nozzle must be located 1 to 3 In. (3 to 8 cm) above the pans may exceed the maximum of 6 sq. ft. (.6 sq. m) <br /> surface of the chain, at the front edge of the appliance, total when modularizing. Tilt skillets and braising pans <br /> and pointed at the opposite diagonal corner. The nozzle generally utilize a hinged cover. Fryer protectio nnozzles <br /> must be aimed parallel to the chain surface. See Figure are to be placed toward the front of the appliance to <br /> 3-16. minimize the potential for the tilt skillet or braising <br /> cover to interfere with the nozzle discharge. See Figure <br /> /iii 3-17. <br /> </ <br /> COVER MUST D <br /> 11 NOZZLE AIMED NOT INTERFERE j <br /> �1 AT OPPOSITE WITH NOZZLE F <br /> 1 044 <br /> �� DIAGONAL CORNER DISCHARGE / Q <br /> 11 <br /> ( FT. <br /> (1.2 mFR) <br /> THE NO ZZLE 19 TOI BE PLACED TOWARD ONT OF THE APPLIANCE <br /> 0 woo, t <br /> TO MINIMIZE THE POTENTIAL FOR THE SKILLET OR BRAISING PAN COVER <br /> O _,.//- ' - ;., ( _ . <br /> rt „,,,,, <br /> TO INTERFE WITH THE NOZZLE DISCHARGE. THE <br /> 1 -3 IN . <br /> (3-8 cm) <br /> COVER MUST <br /> NOT INTERFERE FOR MINIMUM <br /> WITH EDGE OF AND MAXIMUM <br /> DISCHARGE NOZZLE <br /> PATTERN / HEIGHTS, REFER <br /> TO FRYER <br /> _ / NOZZLE <br /> 006190PO PARAMETERS <br /> / I <br /> Figure 3-16. <br /> I <br /> vaomt <br /> h <br /> FRYER NOZZLE USED FOR TILT SKILLET OR BRAISING PAN PROTECTION <br /> MUST BE POSITIONED NEAR THE FRONT EDGE OF THE PAN AND AIMED AT <br /> THE FRONT TO BACK CENTERLINE OF THE PAN. THE DISCHARGE FROM <br /> THE NOZZLE(S) MUST COMPLETELY CLEAR THE PAN COVER WITH AN <br /> UNOBSTRUCTED VIEW TO THE BACK OF THE PAN. <br /> Figure 3 -17. <br /> ULEX 3830 <br /> PN551274(2) AprII 1, 2004 <br />