10-10489 - Laserfiche WebLink

Browse Search

- - . II Id MI Project No, T137-03 Page 3 of 6 i Produaktmet General: ii Test sample was comprised of Goreli Model "G5305" Tilt Double Hung Vinyl Prime, one- over-one (tat loading type) double hung window, with an overall master frame size measuring 54" wide X 77" high X 3-1/4" wide. The bottom sash measured 50-1/8" wide X III 38" high overall. The top sash measured 49-1/4" wide X 37-1/8" high overall. The frame corners were of welded mitered with one screw in bottom corners construction. The sash ims corners were of welded mitered type corner construction. Bottom sash had an exterior I/ aluminum screen. Each sash had (2) foam chimney blocks lowed in the jambs near the balances. One foam chum block for each side of each sash. Each perimeter frame mernber II hollows were filled with stirrofoam pieces that measured to be 7/16" x 9/16". The bottom rail of the bottom sash had a anti bow sway bar attached to the rail and when the window would shut the bar would slide into an opening that was in the center of the sill. 11111 Weather-stripping: MEMBER WEAT'HERSTIPPING QUANTITY WIDTH X HEIGHT LOCATION 1 III (INCHES) Frame Header Insert Center Fin Pile Seal 1 0.187" w x .23" ht 1 side face Frame Sill none 0 none I Frame Jambs none 0 - none Top sash –top rail Center Fin Pile Seal 1 I I 0.187' w x .23" ht I exterior face Top sash –hot rail Center Fin Pile Seal 1 i 0.187" w x .23" lit interior face (keeper mil) U Bottom sash – top rail Center Fin Pile Seal (meeting rail) 1 0.187" w x .23" ht exterior face , • Bottom sash --het rail Center Fin Pile Seal 1 (1.187" w x .23" ht Bottom face I out nil) Foam Filled Bulb Vinyl wi 1 0.3125" Dia. Bottom face th Fin Top sash – jamb stiles Center Fin Pile Seal 1 0.187" w x .23" ht Exterior Pace • Center Fin Pile Seal 1 0.187" w x .23" ht Side face . Bottom sash – jamb dues center FM Pile Seal — 1 0.1.87" w x .23" ht Exterior face Center Firt Pile Seal 1 0.187" w x .23" ht Side face 111 Screen - top rail Pile Seal 1 0.187" w x ,35" ht Interior face Operators and Other Hardware: N Each sash had two sets of (4)constant force balance shoes, one per jamb. One cam-type sweep lock was attached to the center of the bottom sash meeting rail with keeper on top sash meeting rail. One plastic tilt latch with thumb actuator was housed at each end of the top IN rail and interior meeting rail of the bottom sash. One die-cast pivot bar was fastened with (1) screw at each end of the bottom horizontal rails of the top and bottom sash. Each sash had a lift rail with the top sash lift rail on the top rail and the bottom sash lift rail on the bottom rail 1 1 1