|
•
<br /> AS -BUILT DRAWINGS AND INFORMATION CHECKLIST
<br /> Following is a list of information that is to be verified and submitted by the Engineer of Record in support of the
<br /> Statement of Completion.
<br /> 1. On behalf of the permittee, the Engineer shall certify that:
<br /> a. At the time of final inspection, the surface water management system was completed substantially in
<br /> accordance with the permitted construction plans and information. Any minor deviations from the permitting plans
<br /> and specifications will not prevent the system from functioning in compliance with the requirements of Chapters
<br /> 40D-4 and 40D -40, F.A.C. (The as -built drawings and information submitted to the District shall confirm this
<br /> certification.); or
<br /> b. At the time of final inspection, the system was NOT completed in substantial conformance with the
<br /> permitted construction plans and information. (The registered professional engineer shall describe the
<br /> deviation(s) in writing, and provide confirming depiction on the as -built drawings and information.)
<br /> 2. The Engineer's certification shall be based upon on -site observation of construction (scheduled and
<br /> conducted by the professional engineer of record or by a project representative under direct supervision) and
<br /> review of as -built drawings, with field measurements and verification as needed, for the purpose of determining if
<br /> the work was completed in accordance with original permitted construction plans, information and specifications.
<br /> 3. The as -built drawings are to be based on the District permitted construction drawings revised to reflect any
<br /> changes made during construction. Both the original design and constructed condition must be clearly shown.
<br /> The plans need to be clearly labeled as "as- built' or "record" drawings. As required by law, all surveyed
<br /> dimensions and elevations required shall be verified and signed, dated and sealed by a Florida registered
<br /> professional surveyor and mapper or professional engineer. The following information, at a minimum, shall be
<br /> verified on the as -built drawings, and supplemental documents if needed:
<br /> a. Discharge structures - Locations, dimensions and elevations of all, including weirs, orifices, gates,
<br /> pumps, pipes, and oil and grease skimmers;
<br /> b. Side bank and underdrain filters, or exfiltration trenches - locations, dimensions and elevations of all,
<br /> including clean -outs, pipes, connections to control structures and points of discharge to receiving waters;
<br /> c. Storage areas for treatment and attenuation - dimensions, elevations, contours or cross - sections of all,
<br /> sufficient to determine stage - storage relationships of the storage area and the permanent pool depth and volume
<br /> below the control elevation for normally wet systems;
<br /> d. System grading - dimensions, elevations, contours, final grades or cross - sections to determine
<br /> contributing drainage areas, flow directions and conveyance of runoff to the system discharge point(s);
<br /> e. Conveyance - dimensions, elevations, contours, final grades or cross - sections of systems utilized to divert
<br /> off -site runoff around or through the new system;
<br /> f. Water levels - existing water elevation(s) and the date determined;
<br /> g. Benchmark(s) - location and description (minimum of one per major water control structure); and
<br /> h. Wetland mitigation or restoration areas - Show the plan view of all areas, depicting a spatial distribution of
<br /> plantings conducted by zone (if plantings are required by permit), with a list showing all species planted in each
<br /> zone, numbers of each species, sizes, date(s) planted and identification of source of material; also provide the
<br /> dimensions, elevations, contours and representative cross - sections depicting the construction.
<br /> 4. Submit the final subdivision plat or other legal documents, as recorded in the county public records, showing
<br /> dedicated rights -of -way, easement locations and special use areas that are reserved for water management
<br /> purposes and continuing operation and maintenance.
<br /> 5. Additional information will be shown on the as -built drawings or otherwise provided as needed to verify and
<br /> support the Statement of Completion (example: home owners association final documents, and other items
<br /> required by permitting conditions.)
<br /> FORM 547.27/SOC (4/09)
<br /> Rule 40D- 4.351(2)(a)1., F.A.C. Page 3 of 3
<br />
|