Laserfiche WebLink
STEP 6- ATTACHING STRAPS TO STRAP END CHANNELS ON A TRADITIONAL BUTTRESS OVAL <br /> POOL UNLY: <br /> "" - 6MY! IF Y� NAYE A B�TTREF�-F�E AYAL <br /> AL1'�NATE STEP 6. <br /> After you have completed the assembly of a11 of the strap sections, each end of the assembled straps need to <br /> be attached to a strap end channel. Please keep in mind that the strap nms underneath the liner of the pool, so it <br /> should be attached to the open end of the channel, not the side where the strut cannects. <br /> The straps connect to the channels, along with the end channel caps, shown in Fig.19 and Fig.20 using two <br /> 5/16 X�2 � bolts and two 5/16" nuts at every connection. Be sure to attach the straps to the underside of the strap <br /> end channels. The heads of the bolts go on top of the channel, and the nuts should be on the under side. Aiways <br /> use the two holes closest to the end of the strap end channels when connecting the strap sections to the channel. <br /> 5/16' x 1l'2' BoKs <br /> � <br /> 5I1 S' Nuts <br /> Fig. 18 15 r <br /> As you are bolting the strap to the strap end channels, add the end channel caps to the under side of the straps at each end <br /> as shown in Fig.19 and Fig.20 <br /> When t�ese end channel caps are lined up properly, the two holes in these end channel caps will line up wi� the two holes <br /> in the straps, as well as, �e corresponding holes in the strap end channeLs themselves. <br /> These end channel caps are secured in place using the same two 5/16" x%a" bolts and 5/16" nuts that are used to secure �e <br /> suaps to the strap end channels. <br /> �� �� P� ���1� �rnectly �ey will cover the openings at the ends of the channels. 'This w�1t prevent �e sand <br /> base of your pool from washing into these channels once ti�e pool is filled with water. <br /> � <br /> ' — — <br /> � � a _ B <br /> — <br /> 0 0 <br /> s <br /> � <br /> � � <br /> strap end strap end <br /> Fig. 19 channel cap �. 20 d�annel cap <br />