Laserfiche WebLink
Sii»�v/e.�xGr�inne// �� � � � �� � <br /> ATyco lnternational Company <br /> ' Technical Installer Support <br /> � (TIS) <br /> � <br /> ,� TIS is designed to make the expertise of a Simplex technician available at key,scheduled times <br /> ' during the project. This service is available during normal Simplex working hours,if scheduled <br /> five working days in advance. <br /> � <br /> i TIS includes the following activities by a factory-trained technician,when determined by Simplex , <br /> ' to be appropriate. <br /> I <br /> ' Pre-construction review of submittals and drawings with the installer. <br /> ITechnical advice during initial start up of control panels(including transponders) before installer . <br /> wiring is connected. <br /> ' Review of panel wiring,and preparation of a list of any items to be corrected by the installer. <br /> � <br /> Initial programming of contro)equipment. <br /> Program editing to correct minor errors and omissions. <br /> i <br /> � <br /> Assistance with one complete,functional test of the system. <br /> � One training session for the owner's representative. <br /> � Additional installation support may be purchased from Simplex. <br /> ' TIS contributes significantly to the installation of Simplex equipment but does not alleviate the <br /> installer's responsibility to: <br /> Provide skilled labor and supervision to complete the project. <br /> Review and understand Simplex instructions for installing and testing Simplex equipment. <br /> ; Potential problems can be avoided by adhering to the following: <br /> Do not initially start up the system,except in the presence of a Simplex technician. Simplex <br /> , assumes no liability for damaged equipment,and warranty may be voided it this procedure is <br /> not followed. <br /> ; Do not install smoke detectors(unless protected by plastic bags)until final construction clean up <br /> has occurred. This prevents damage caused by dust,dirt,and paint. Detectors installed prior to <br /> clean up may requite disassemble,cleaning,or replacement which is not covered by warranty. <br /> Care must be taken to protect equipment during the installation and warranty period. Failures <br /> , due to external causes(lighting surges,construction dust,water damage,etc.)will be repaired by , <br />