12-13001 - Laserfiche WebLink

Browse Search

SpectrAlert Advance Specifications , G.;nera! SpectrAlert Advance homs,strobes and hom/strobes shall mount to a standard 4 x 4 x i�/�-inch back box,4-inch octagon back box or double-gang back box.Two-wire products shall also mount to a sing�e-gang�x 4 x 1�/s-inch back box.A universal mounting plate shall be used for mounting ceiling and wall products.The notification appliance circuit wiring shall terminate at the universal mounting plate.Also,SpectrAlert Advance produas,when used with the Sync•Grcuit"Module accessory,shall be powered from a non-coded noUficanon apphance circuit output and shall operate on a nominal 12 or 24 volu.When used with the Sync•Circwt Module,12 volt rated notfication appliance circuit outputs shall operate between nine and 17.5 volts;��4-volt rated notification appliance circuit outputs shall operate between 17 and 33 volts Indoor SpectrAlert Advance producis shall operate between 3�and 120 degrees Fahrenheit from a regulated DC,or full-wave rectfied,unfiltered power supply Strobes and horn/strobes shall have field-selectable candela settings induding 15,15/75,30, 75,95,1 10,1 15,135,150,177,185 Strnbe The strobe shall be a System Sensor SpectrAlert Advance Model hsted to UL 1971 and shall be approved for fire protective service.The strobe shall be wired as a primary-signaling notification appliance and comply with the Amencans with Disabilities Act requirements for visible signahng appliances,flashing at 1 Hz over the strobe's entire operating voltage range.The strobe light shall consist of a xenon flash tube and assoaated lens/reflector system Har��;5trc}be Cornbmation The horn/strobe shall be a System Sensor SpectrAlert Advance Model listed to UL 1971 and UL 464 and shall be approved for fire protec[ive service. The hom/strobe shall be wired as a primary-signaling notfication appliance and comply wrth the Americans with Disabilities Act requirements for visible signaling appliances,flashing at 1 Hz over the strobe's entire operating voltage range.The strobe light shall consist of a xenon flash tube and associated lens/reflector system.The hom shall have three audibility options and an option to switch between a temporal three-pattem and a non-temporai(continuous) pattern These options are set by a multiple position switch.On four-wire products,the strobe shall be powered independently of the sounder The hom on horn/strobe models shall operate on a coded or non-coded power supply Otrtdoor Prrsducis SpectrAlert Advance outdoor horns,strobes and hom/strobes shall be listed for outdoor use by UL and shall operate between minus 40 degrees and 151 degrees Fahrenheit The producu shall be listed for use with a System Sensor outdoor/weatherproof back box with half inch and three-fourths mch conduit entnes. Synthronization Module The module shall be a System Sensor SynaCircwt model MDL hsted to UL 464 and shall be approved for fire protective service.The module shall synchronize SpectrAlert strobes at 1 Hz and homs at temporal three.Also,while operating the strobes,the module shall silence the horns on horn/strobe models over a single pair of wires.The module shall mount to a 4��/,e x 4��/,6 x 2�/a-inch back box The module shall also control two Style Y(dass 2)arcuits or one Sryle Z (class A)arcuit The module shall synchronize muhiple zones.Daisy chairnng two or more synchronization modules together will synchrornze all the zones they control.The module shall not operate on a coded power supply 5tandard OperaUng Temperature 32°F to 120°F(0°C to 49°Q K Series Operating Temperature —40°F to 151°F(-40°C to 66°C) Numidity R�nye 10 to 9396 non-condensing(indoor products) Strob�Fiash Rate 1 flash per second Nominal Volta9e Regulated 7 2DC/FWR or regulated 24DC/FWR' Operatinq Voftaye Range� 8 to 17.5 V(12V nominal)or 16 to 33 V(24 nominaD �nput terminal wire yauge 12 to 18 AWG �eil�ny mount dimensions{induding lens) 6.8 diameter x 2.5"high(173 mm diameter x 64 mm high) Wali rr�ount dimensions(induding tens) 5 6"L x 4 7"UV x Z5"D(142 mm L x 1 19 mm W x E4 mm D) Horn dimens�oris 5.61 x 4J"W x 1 3"D(142 mm�.x 119 mm W x 33 mm D) LVall-maunt back b�x skirt dimensions fgBS-2,BBSW-21 5 9°L x 5 0'W x Z2"D(151 mm L x 128 mm W x 56 mm D) Ceiling mauirt b��ck box skirt dimensions iBB5G2,BBSCW-21 7 1"diameter x 2 25"high(180 mm diameter x 5'mm high) Wali rnount weatherproof back box dimensions(SA-WBBi 5 7"L x S 1"W x 2.0"D(145 mm L x 130 mm W x 51 mm D) �eilinc7-mount weatherproof back box dimensions(SA-WBBC} 7 1""diameter x 20"high(180 mm diameter x 51 �nm high) "�GtPS. 1 Full Wave Rectified(FWR)voltage is a non-regulated,time varying power source that is used on some power supply and panel outputs ?.P,S,PC,and SC products will operate at 12 V nominal only for 15 and 15/75 cd 405-C395-0C4