Laserfiche WebLink
SpectrAlert Advance Specifications <br /> Generel <br /> SpectrAlert Advance homs,strobes,and hom strobes shall mount to a standard 4 x 4 x l Yz-inch back box,4-inch octagon back box,or double-gang back <br /> box.Two-wire products shall also mount to a single-gang 2 x 4 x P/a-inch back box.A unroersal mounting plate shall be used for mounung ceiling and <br /> wall products.The notification appliance circuit wiring shall terminate at the universal mounting plate.Also,SpectrAlert Advance products,when used with <br /> the SynaCircuit"Module accessory,shali be powered from a non-coded notification appliance circuit output and shall operate on a nominal 12 or 24 volts. <br /> When used with the Syno-Circuit Module,12-volt-rated notification appliance circuit outputs shall operate between 9 and U.5 volts,24volt-rated notification <br /> appliance circuit outputs shall operate between 17 and 33 volts.Indoor SpectrAlert Advance products shall operete between 32 and 120 degrees Fahrenheit <br /> Rom a regulated DC or full-wave rectified unfiltered power supply Strobes and hom strobes shall have field-selectable candela setti�gs including 15,15/75,30, <br /> 75,95,110,115,135,150,177,and 185 <br /> Strobe <br /> The strobe shall be a System Sensor SpectrAlert Advance Model listed to UL 1971 and shall be approved for fire protective service.The strobe shall be <br /> wired as a primary-signaling notification appliance and compiy with the Americans with Disabilities Act requirements for visible signaling appliances,flashing at <br /> 1 Hz over the strobe's entire operatmg voltage range.The strobe Iight shall consist of a xenon flash tube and associated lens/reflector system. <br /> Horn Strobe Combination <br /> The hom strobe shall be a System Sensor SpectrAlert Advance Model listed to UL 1971 and UL 464 and shali be approved for fire protective service.The <br /> horn strobe shall be wired as a primary-signaling notification appliance and complywith the Americans with Disabilities Act requirements for visible signaling <br /> appliances,flashing at 1 Hz over the strobe's entire operating voltage range.The strobe light shall consist of a xenon flash tube and associated lens/reflector <br /> system The hom shall have three audibility options and an option to switch between a temporal three pattem and a non-temporal(continuous)pattern.These <br /> options are set by a multiple position switch.On four-wire products,the strobe shall be powered independently of the sounder.The horn on horn strobe models <br /> shall operate on a coded or non-coded power supply <br /> Synchronization Module <br /> The module shall be a System Sensor SynaCircuit model MDL listed to UL 464 and shall be approved for fire protective service.The module shall synchronize <br /> SpectrAlert strobes at 1 Hz and homs at temporal three.Also,while operating the strobes,the module shall silence the homs on hom strobe models over a <br /> single pair of wires.The module shall mount to a 4��/,6 x 4��/,b x 2�/e-inch back box.The module shall also control two Style Y(class B)circuits or one Style Z <br /> (dass A)circuit.The module shall synchronize multiple zones.Daisy chaining two or more synchronization modules together will synchronize all the zones they <br /> control.The module shall not operate on a coded power supply <br /> Standard Opereting Tempereture 32°F to 120°F(0°C to 49°C) <br /> Humidity Range 10 to 9396 non-condensing <br /> Strobe Flash Rate 1 flash per second <br /> Nominal Voltage Regulated 12 DCJFWR or regulated 24 DCIFWR' <br /> Operating Voltage Range2 8 to 175 V(12 V nominal)or 16 to 33 V(24V nominal) <br /> InputTerminal Wire Gauge 12 to 1 S AWG <br /> Wall-Mount Dimensions(including lens) 5.6"L x 4.7"W x 2.5"D(142 mm L x 119 mm W�:64 mm D) <br /> Horn Dimensions 5.6"L x 4.7"W x 1.3"D(142 mm L x 119 mm W�;33 mm D) <br /> Wall-Mount Back Box Skirt Dimensions(BBS-2,BBSW-2) 5.9"L x 5.0"W x 2.2"D(1 S 1 mm L x 128 mm W�;56 mm D) <br /> Wall-Mount Trim Ring Dimensions(sold as a 5 pack)(TR-H5,TRW-HS) 5.7"L x 4.8"W x 0.35"D(145 mm L x 122 mm W x 9 mm D) <br /> Notes: <br /> i Full Wave Rectified(FWR)voltage is a non-requlated,time-varying power source that is used on some power supply and panei outputs. <br /> 2.P,S,PC,and SC products will operate at 1�V nominal onlyfor 15 and 1 S/75 cd. <br /> nwsooboa <br />