13-14152 - Laserfiche WebLink

Browse Search

SpectrAlert Advance Specfications . , Generaf SpectrAlert Advance horns,strobes,and horn strobes shall mount to a standard 4 x 4 x 1 Yz-inch back box,4-inch octagon back box,or double-gang back box.Two-wire products shall also mount to a single-gang 2 x 4 x 17B-inch back box.A universal mounting plate shall be used for mounting ceiling and wall products.The notification appliance circuit wiring shall terminate at the universal mounting plate. Also,SpectrAlert Advance products.when used with the Sync•Circuit"'Module accessory,shall be powered from a non-coded notification appliance circuit output and shall operate on a nominal 12 or 24 volts.When used with the Sync•Circuit Module, 12-volt rated notification appliance circuit outputs shall operate between 8 and 17.5 volts;24volt-rated notification appliance circuit outputs shall operate between 16 and 33 volts.Indoor SpectrAlert Advance products shall operate between 32 and 120 degrees Fahrenheit from a regulated DC or fuli-wave rectified unfiltered power suppiy.Strobes and horn strobes shall have field-selectable candela settings including 15, 15/75,30,75,95,110, 115,135, 150, 177,and 185. Strobe The strobe shall be a System Sensor SpectrAlert Advance Model listed to UL 1971 and shail be approved for fire protective service. The strobe shall be wired as a primary-signaling notification appliance and comply with the Americans with Disabilities Act requirements for visible signaling appliances,flashing at 1 Hz over the strobe's entire operating voltage range.The strobe light shall consist of a xenon flash tube and associated lens/reflector system. Hom Strobe Combination The horn strobe shall be a System Sensor SpectrAlert Advance Model listed to UL 1971 and UL 464 and shall be approved for fire protective service.The horn strobe shall be wired as a primary-signaling notification appliance and comply with the Americans with Disabilities Act requirements for visible signaling appliances,flashing at 1 Hz over the strobe's entire operating voltage range.The strobe light shall consist of a xenon flash tube and associated lens/reflector system.The horn shall have three audibility options and an option to switch between a temporai three pattern and a non-temporal(continuous)pattern.These options are set by a muftipie position switch.On four-wire products,the strobe shall be powered independently of the sounder.The horn on horn strobe models shall operate on a coded or non-coded power supply. Synchroniza4ion Module The module shall be a System Sensor Sync•Circuit model MDL listed to UL 464 and shall be approved for fire protective service.The module shall synchronize SpectrAlert strobes at 1 Hz and horns at temporal three.Also,while operating the strobes,the module shall silence the horns on horn strobe modeis over a single pair of wires.The module shall mount to a 411/16 x 411/16 x 21B-inch back box.The module shall also control two Style Y(class 6)circuits or one Style Z(class A)circuit.The module shall synchronize multipie zones.Daisy chaining rivo or more synchronization modules together will synchronize all the zones they control.The module shall not operate on a coded power supply. Standard Operating Temperature 32°F to 120°F(0°C to 49°C) Humidity Range 10 to 93°�non-condensing Strobe Flash Rate 1 flash per seCOnd Nominal Vo4tage Regulated�2 DC/FWR or regulated 24 DC/FWR' Operating Yoltage Range2 8 to 17.5 V{12 V nominal)or 16 to 33 V(24 V nominal) Input Terminai Wtre Gauge 12 to 18 AWG Wall-Mount Dimensions(including lens) 5.6"L x 4 7"W x 2.5"D(142 mm L x 119 mm W x 64 mm D) Hom Dimensions 5.6"L x 4.7"W x 1.3"D(142 mm L x 119 mm W x 33 mm D) Wail-Mount Back Box Skirt Dimensions(BBS-2,BBSW 2) 5.9"L x 5.0"W x 2.2"D(151 mm L x'128 mm W x 56 mm D) Wall-Mount Trim Ring Dimenslons(sold as a 5 pack){TR-HS,TRW- 5.7"L x 4.8`W x 0.35"D(145 mm L x 122 mm W x 9 mm D) Hs) Notes: 1 Full Wave Rectified(FWR)voltage is a non-regulated,time-varying power source that is used on some power supply and panel outputs. 2.P,S,PC,and SC products will operate at 12 V nominal only for 15 and 15/75 cd. AVDS00601