13-14422 - Laserfiche WebLink

Browse Search

SpectrAlert qdvance Outdoor Horn,Strobe,and Hom Strobe gpecifications Generat SpecVAlert Advance outdoor homs,strobes,and horn strobes shail mount to a weatherproof back box.A universai mounting pfate shall be used for mounting ceiling and wall products.The notification appliance circuit wiring shall terminate at the universal mounting piate. Also,SpectrAlert Advance products,when used with the Sync•Circuit""Module accessory,shall be powered from a norrcoded notificaUOn appliance circuit outpuc and shall operate on a nominal 12 or 24 volts.When used with the Sync•Circuit Module,12-volt-rated nobfication appliance circuit outputs shail operate between 9 and 17.5 voits;24voit rated notification appliance circuit outputs shall operate between 17 and 33 volts.Outdoor SpecVAlert Advance products shall operate between-qp and 151 degrees Fahrenheit from a regulated DC or full-wave rectified unfiftered power supply.Strobes and hom strobes shall have fieid-selectable candela settings including 15, 15/75,30,75,95,110, 115,135,150,177,and 185. Strobe The strobe shafi be a System Sensor SpectrAfert Advance Model listed to UL 1971 and shali be approved for fire protective service. The strobe shali be wired as a primary-signaling nolification appliance and comply with the Americans with Disabilities Act requiremerrts for visible signafing appliances,flashing at 1 Hz over the strobe's entire operating voltage range.The strobe light shali consist of a xenon fiash tube and associated lens/reflector system.The strobe must be installed with its weatherproof back box in order to remain outdoor approved per UL.The strobe shall be suitable for use in wet environments. Hom Strobe Combination The hom strobe shall be a System Sensor SpectrA(ert Advance Model listed to UL 1971 and UL 464 and shail be approved for fire protective service.The horn strobe shall be wired as a primary-signaling notification appliance and comply with the Americans with Disabilities Act requirements for visible signaling appiiances,flashing at 1 Hz over the strobe's entire operating vottage range.The strobe light sha(I consist of a xenon flash tube and associated lens/reflector system.The horn shall have three audibility options and an op�on to switch between a temporal three pattem and a non-temporal(corrtinuous)pattern.These options shatl be set by a multiple position switch. On four-wire products,the strobe shall be powered independenify of the sounder.The hom or horn strobe models shall operate on a coded or rwn-coded power supply.The horn strobe must be instafled with its weatherproof back box in order to remain outdoor approved per UL The hom strobe shall be suitable for use in wet environments. Operating Temperature -4U°F to 151°F(-40°C to 66°C) Strobe Flash Rate 1 flash per second Nominat Voitage Operatin Vo Regulated 12 DC/FWR or regulated 24 OC/F1NR' g ftage Range2 8 to�7.5 V(12 V nominal)or 16 to 33 V(24 V nominal) tnput Terminal Wire Gauge 12 to 18 AWG Wali-Mount Dimertsions(including lens) 5.6"L x 4.7"W x 2.5"D(142 mm L x'I 19 mm W x 64 mm D) Hom Dimertsions 5.6"L x 4.7"W x�.3"D(142 mm L x 119 mm W x 33 mm D) WaH-Mount Weatherpr+oof gack gox pimensions(SA-WBg) 5.7"L x 5.'I"W x 2.0"D(145 mm L x 130 mm W x 51 mm D) Notes: 1.Fuli Wave Rectified(FWR)voltage is a non-regulated,time-varying power source that is used on some power supply and panei outputs. 2.P,S,PC,and SC products wili operate at�2 V nominal only for 15 and 15l75 cd. AVp$p120t