13-14692 - Laserfiche WebLink

Browse Search

TRINITY ERD 6. INSTALLATION: 6.1 Polyglass Roof Underlayments shall be installed in accordance with Polyglass published installation requirements subject to the Limitations set forth in Section 5 herein and the specifics noted below. 6.2 Re-fasten any loose decking panels, and check for protruding nail heads. Sweep the substrate thoroughly to remove any dust and debris prior to application, and prime the substrate (if applicable). 6.3 Elastobase Elastobase P or Mule-Hide Nail Base• 6.3.1 Shall be installed in compliance with the codified requirements for ASTM D226, Type II underlayment in FBC Sections 1507 for the type of prepared roof covering to be installed. 6.3.2 For use in non-tile applications: 6.3.2.1 Reference is made to the current edition of the NRCA Steep-slope Roofing Manual and ARMA recommendations for installing shingle underlayments and flashings 6.3.2.2 Elastobase, Elastobase P or Mule-Hide Nail Base may be covered with a layer of Polystick, Polyflex SAP or SAP FR, Mule-Hide SA-APP Cap Sheet or SA-APP Cap Sheet (FR), Dual Pro or Tile Pro, self-adhered, Elastoflex S6 G or S6 G FR in hot asphalt or Polyflex G or G FR, torch applied. 6.3.3 For use in tile applications, reference is made to Polyglass published installation instructions in conjunction with FRSA/TRI 07320/8-05 Installation Manual, Fourth Edition, and Table 2 herein. 6.4 Polvstick MTS. IR-Xe, TU, TU P, TU Plus TU Max Polvflex SAP or SAP FR Mule Hide SA-APP Can Sheet or SA-APP Cao Sheet (FR) Dual Pro or Tile Pro• 6.4.1 Shall be installed in compliance with the codified requirements for ASTM D1970 underlayment in FBC Sections 1507 for the type of prepared roof covering to be installed. 6.4.2 For non-tile applications: 6.4.2.1 All self-adhering materials, with the exception of Polystick TU Plus, Polyflex SAP or SAP FR and Mule-Hide SA-APP Cap Sheet or SA-APP Cap Sheet (FR) should be back-nailed in selvage edge seam in accordance with Polyglass / Mule-Hide Back Nailing Guide. Nails shall be corrosion resistant, li gauge ring-shank type with a minimum 1-inch diameter metal disk or Simplex-type metal cap nail, at a minimum rate of 12" o.c. Polystick TU Plus should be back- nailed using the above noted fasteners and spacing, in area marked "nail area, area para clavar" on the face of inembrane. The head lap membrane is to cover the area being back- nailed 6.4.2.2 All seal-lap seams (selvage laps) must � be firmly rolled with a minimum 28 Ib. ' ' � hand roller to ensure full contact and '� � adhesion. For Dual Pro and Tile Pro, '�� •" align the edge of the top sheet to the ��°,;� .-:� end of the glue pattern (the sheet will ' ° ^;;'w " overlap the fabric). ��' „�•• � . °�.- � �� h.�� F;�p� �� C' ��.�# ' �� �°� ��. View of Ovelap Seam of Dual Pro and Tile Pro Exterior Research and Design, LLC. Evaluation Report P12060.02.09-R13 Certificate ofAuthorization#9503 FL5259-R18 Revision 13: 04/26/2013 Page 8 of 10