Laserfiche WebLink
Membrane Type: Single Ply,Thermoplastic,TPO,Remforced <br /> Deck Type 11: Wood,Insulated <br /> Deck Description: '°/32" or greater plywood or wood plank <br /> System Type D: Membrane mechanically attached over prelimmarily fastened insulation. <br /> A11 General and System Limitations apply.Roof accessories not listed in Tabie 1 of this NOA are not approved <br /> and shall not be installed untess said accessories demonstrate compliance with prescriptive Florida Building <br /> Code requirements and are field fabricated utilizing the approved membranes listed in Table 1. <br /> Insulation Laver Insulation Fasteners Fastener <br /> Table 3 Density/ft2 <br /> Polyisocyanurate HP-H,Poly ISO-1 <br /> Minimum 1.5"thick N/A N/A <br /> Note: All layers of insulation and base sheet shall be simultaneously attached. See base sheet below for fasteners <br /> and density. Refer to Rooting Application Standard RAS 117 for insulation attachment requirements. <br /> lnsulation shall have preliminary attachment, prior to the installation of the roofing membrane. At an <br /> application rate of two fasteners per board for insulation boards having no dimension greater than 4 ft., and <br /> four fasteners for any insulation board having no dimension greater than S ft. <br /> Vapor Retarder: (Optional) Any UL or FMRC approved vapor retarder applied to the roof deck or over a base <br /> layer of insulahon. <br /> Barrier: '/4",3!R", '/2",or 5/s" gypsum. <br /> Membrane: TPO-c, TPO-c FR, TPO-c EXTRA, Reinforced, secured through the preliminarily attached <br /> insulation as specified below. <br /> Fastening#1: EHD Fasteners with Piranha Plates 6" o.c. through the membrane m the 5'/2" side lap m rows <br /> spaced 6'o.c followed by applying a 1'/z"wide heat weld. <br /> Maximum Design Pressure-67.S psf.� (See General Limitation#� <br /> Fastening#2: EHD Fasteners with Piranha Plates 6" o.c. through the membrane m the 5'/2" side lap m rows <br /> spaced 8'o.c. followed by applying a 1'/z"wide heat weld. <br /> Maximum Uesign Pressure-�2.5 psf.� (See Ueneral Limitation#7) <br /> Maacimum Design <br /> Pressure: See Fastemng Options Above <br /> NOA No.: 13-0411.03 <br /> MIAMHWIDEC uH'rY Expiration Date: 08/31l14 <br /> ,...• � <br /> Approval Date: 08/29/13 <br /> Page 9 of 10 <br />