Laserfiche WebLink
Membrane Type: Singte Pty,Thermoplastic,TPO.Reinforced,Fleecebacked <br /> Deck Type ZI: Steel, Insulated <br /> Deck Description: 18-22 ga, steel <br /> System Tvpe C(3): All layers of insulation simultaneously attached:membrane fully adhered. <br /> Ali General and System Limitations apply.Roof accessories not listed in?able 1 of this NOA are not approved <br /> and shaii not be installed ualess said accessuries demonstrate compiiance with prescriptive Florida Buitding <br /> Code requirements and are field f�brics�ted utilizing the approved membranes listed in Tab[e 1. <br /> Base or Top Insulatiun Laver Insulation Fastcners F •tencr <br /> Table 3 Densitv/ft2 <br /> ENRGY-2,ENRGY-3,PSI-25,AC Foam II,Polyisocyxnurate HP,Polyisocyxnurate HP-W,HP-H, <br /> P�lyisocyanurate HP-N,Poly ISO 1 <br /> Minimu�n 2"thick 1,2, IS,2(>.21 or 2�3 i:1.G ft2 <br /> Note: All l�yers shHtl be simuttaneously fastenect; see top layer below for fasteners and densit,y. Insulation <br /> ��ncls listed are minimum sizes and dimensions; if targer panels are used,the number of fasteners shali bc <br /> increase�l maintaining the same fastener density. Please refer to Roofing A�ptication Standard RAS 1 U for <br /> insulation attachment. Single and muldple tayers of insulation can be attached to base layer with Carlis(e Syntec <br /> FAST Adhesive. <br /> Note: Insutation panels listed are minimum sizes and dimensions;if larger panels are used,the number of <br /> fasteners shalt be increased maintaining the same fastener density. Please refer to Roafing Application St�ndard <br /> RAS 117 for insulation attachment. <br /> Vt�ptrr Retarder: (Optional) Any UL or FMRC approved vapor retarder applied to the roof deck or o��er a base <br /> layer oF insulatian. <br /> Barrier: None. <br /> P�iembrane#1: TPO-c or TPO-c FR, Reinforced, 45 or (0 mil membrane or TPQ-c EXTRA, 72 or 80 mii <br /> membrane fully adhered to the insulAtion using TPO Bonding Adhesive applied to the substrnte <br /> at a rate of I gaU60 ft.� <br /> Maximuni Design Pressure—75 psf(.See Genera!l.imitutian#7) <br /> nlembranc#Z: TPO-c FlecceBACK Plus membrane adhercd to the insulation using Cold Applied Adhesive <br /> applied to the substrate nt a rate of 1 gallG7 ft,= <br /> Maxirnrim Design Pressr�re—h0 psJ(.See Genera/Limitatinn#7) <br /> M�ximum Design <br /> Pressure: See Membrane Options Above <br /> � I� ��I�I � i�OA Na.: 13-1�t 1.IW <br /> • ► Expiration Date: 08/31/14 <br /> �pProval Date: 08/29/13 <br /> PaQc 12 ot 18 <br />