14-15069 - Laserfiche WebLink

Browse Search

• MIAMI•QADE MIAMI—DADE COUNTY,FLORIDA � PRODUCT CONTROL SECTION DEPARTMENT OF REGULATORY AND ECONOMIC RESOURCES(RER) 11805 SW 26 Street,Room 208 BOARD AND CODE ADMINISTRATION DIVISION T(786)315-2590 F(786)315-2599 NOTICE OF ACCEPTANCE (NOA) www.miamidade.aov/economv Pella Corporation 102 Main Street Pella,IA 50219 SCOPE: This NOA is being issued under the applicable rules and regulations governing the use of construction materials. The documentation submitted has been reviewed and accepted by Miami—Dade County RER— Product Control Section to be used in Miami—Dade County and other areas where allowed by the Authority Having Jurisdiction(AHJ). T'his NOA shall not be valid after the expiration date stated below. The Miami—Dade County Product Contro) Section(In Mi��ni—Dade County)and/or the AHJ(in areas other than Miami—Dade County)reserve the right to have this product or material tested for quality assurance purposes. If this product or material fails to perform in the accepted manner,the manufacturer will incur the expense of such testing and the AHJ may immediatety revoke, modify, or suspend the use of such product or material within their jurisdiction. RER reserves the right to revoke this acceptance, if it is determined by Miami—Dade County Product Control Section that this product or material fails to meet the requirements of the applicable building code. This product is approved as described herein, and has been designed to comply with the Florida Building Code,including the High Velocity Hurricane Zone. DESCRIPTION: Series"10 Vinyl Y:" Flange"White PVC Single Hung Window—N.I. APPROVAL DOCUMENT: Drawing No. 1840, titled "10 Series Vinyl Non—Impact Single Hung Window", sheets 1 through 4 of 4, dated 10/10/12 with the latest revision dated O1/10/13, prepared by W. W. Schaefer Engineering & Consulting, P.A., signed and sealed by Warren W. Schaefer, P. E., bearing the Miami—Dade County Product Control Section Approval stamp with the Notice of Acceptance number and Approval date by the M:iami—Dade County Product Control Section. MISSILE IMPACT RATING: None. LIMITATIOM: The maximum anchor spacing at the Head and Sill shall NOT to exceed 12—inch on center if the design pressure is greater 50 psf. LABELING: Each unit shall bear a permanent label with the manufacturer's nanne or logo, city, state, model/series, and following statement: "Miami—Dade County Product Control Approved", unless otherwise noted herein. RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been no change in the applicable building code negatively affecting the performance of this product. TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change in the materials, use, and/or manufacture of the product or process. Misuse of this NOA as an endorsement of any product, for sales, advertising or any other purposes shall automatically terminate this NOA. Failure to comply with any section of this NOA shall be cause for termination and removal of NOA. .ADVERTISEMENT: The NOA number preceded by the words Miami—Dade County, Florida, and followed by the expiration date may be displayed in advertising literature. If any portion of the NOA is displayed,then it shall be done in its entirety. INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its distributors and shall be available for inspection at the job site at the request of the Building Official. 'This NOA consists of this page 1 and evidence pages E-1 and �2,as we11 as approval document mentioned above. 'The submitted documentation was reviewed by Jaime D. Gascon,P.E. NOA No. 12-1108.02 MWMI•DADE COUN7'Y Expiration Date: January 31 2018 i � � � �� Approval Date: January 31,2013 � zs Page 1