14-14307 - Laserfiche WebLink

Browse Search

� � LINER INSTALLATION Before installing the liner, make sure that the pool 6. Continue placing the linerbead into the walls, pool bottom, coping, and generat working extrusion, working along ea�h side toward the area is clean and free of sharp materials that could deep end until the deep end corners are in snag or puncture your liner. Tape over any sharp place. edges on the pool coping. 7. Be sure that the bottom corners in the shallow end of the pool are flush against the wall. Four people will be required for the installation of Place the filled water tubes along the shallow your liner. end wall to hold the liner in position. 1. Locate your industriat vacuum at the skimmer. 8. Shift the Ifner around the pool perimeter as Insert the suction hose into the skimmer from 'required to position the corners correcily. the cover,out the front, and down the pool wall to within 3"of the bottom. Tape around the skimmer cover opening to secure an airtight fit. Final Positioning of the Liner 2. Place the liner at the deep end of the pool. 1.Turn the vacuum on and pull out any liner Unfold as illustrated on the box. wrinkles and adjust the liner to match the pool bottom. Wrinkles can be removed by reaching 3. While two people hold the liner on the coping over the wail and pulling on the liner sidewall at tl�e deep end,two persons should begin to material. walk the liner to the shallow end. If necessary,turn the vacuum off to reposition 4. Position the liner squa�ely in the pool. �ach the liner. Then turn it on again. corner of the liner is marked on the back side. 5. Secure the liner in the shallow end fir5t. PIaCe 2.Once the liner is positioned properly and wrinkles have been the liner bead into the receptor extrusion along removed,fill ct,e pool with water. the shallow end wall, making sure the corners are in position. If your pool has a main drain,install the face ring,gasket, and cover after there is approximately 12"of water in the deep end. Follow the manufacturer's instructions. NOTE: Leave the vacuum i�place and running until the water reaches a depth of at least2"in the shallow end.Itthevacuum is removed befo�e the water reaches this point,the liner may slide toward the deep end,c�eating unsightly wrinkles and possibly causing damage to the liner. If the vacuum is shu! Installation of Faceplates for Skimmer, off too soon,drain the pool immediately and reposition the Return Fittings, Light, and Safety Rope liner. 3.When the water level reaches 2"in the shallow end,turn the NOTE: Do not install the faceplates for the skimmer,return vacuum off and remove it from the skimmer opening. Adjust fittings,Ifght,or safety rope until the water level is well over the liner if necessary,then continue filling the pool to normal the fltti�gs! If they are installed and cut in too soon,the liner operating depth. may shift as it fills,causing it to tear at the tittings! , 1.Position the faceplate over the fittings so that the holes fine up. 2.With a pofnted tool,penetrate the liner where each hole is and affix the faceplate with the self tapping screw provided with the fitting. 3.Cut out the opening with a razor knife.