Laserfiche WebLink
i. <br /> TRINIIY�ERD <br /> 5.4 Allowable roof covers applied atop the nderlayments are follows: <br /> Tabl 1: Roof Cover Options <br /> Asphalt Foam-On �Nood Slate� <br /> Underlayment Shingles Nail-On Ti e T11e Metal Shakes& Synthetic <br /> Shingles Slate/Shake <br /> CCW WIP100 Yes No No No No No <br /> CCW WIP 250 Yes No No Yes No No <br /> CCW WIP 300HT Yes No No Yes No Yes <br /> 5.5 Allowable substrates are noted below: <br /> 5.5.1 Direct-Bond to Deck: <br /> Self-adhering membranes applied to: <br /> ➢ New untreated plywood; <br /> ➢ Primed new untreated plywood; <br /> ➢ Existing plywood; <br /> ➢ Primed existing plywood; <br /> Note: While not required, CCW-70 0� CAV-GRIP prime� may be used when deemed <br /> app�opriate or when tempe�atures are be%w 40°F. <br /> 5.5.2 Bond to Mechanicall Attached Base L er: <br /> Self-adhering membranes applied to: <br /> ➢ ASTM D226, Type I or II felt; <br /> For installations under mechanically attached prepared roof coverings, base layer shall be <br /> attached per minimum codified requir ments. <br /> 5.6 Exposure Limitations: <br /> 5.6.1 CCW WIP 100, CCW WIP 250 and C W WIP 300HT shall not be left exposed for longer than <br /> 30-days after installation. <br /> 6. INSTALLATION: <br /> 6.1 CCW Roof Underlayments shall e instailed in accordance with Carlisle Coatings & <br /> Waterproofing published installatio requirements subject to the Limitations set forth in <br /> Section 5 herein and the specifics no ed below. <br /> 6.2 Re-fasten any loose decking panel , and check for protruding nail heads. Sweep the <br /> substrate thoroughly to remove any ust and debris prior to application. Prime the substrate <br /> (if applicable) with CCW-702 or CAV GRIP Primer. <br /> 6.3 CCW WIP 100 CCW WIP 250 and C WIP 300HT: <br /> 6.3.1 Shall be installed in compliance with the requirements for ASTM D1970 underlayment in FBC <br /> Sections 1507 for the type of prepar d roof covering to be installed. <br /> 6.3.2 While not required, CCW-702 or CA -GRIP primer may be used when deemed appropriate. <br /> Priming is required when temperatur s are below 40°F. <br /> 6.3.3 Cut WIP roofing underlayment into 1 to 15 ft lengths. Remove 2 to 3 ft of release film and <br /> align the edge of the membrane, sti ky-side down, so it overhangs the drip edge by 3/8-inch. <br /> Continue to remove release film and press as you move across the roof. Use a hand roller <br /> and/or hand pressure to press into p ace. <br /> Exterior Research and Design, LLC. Evaluation Report C39180.12.11-R2 <br /> Certifcate ofAuthorization#9503 FL6785-R5 <br /> Revision 2: 10/12/2012 <br /> Page 3 of 4 <br />