15-15894 - Laserfiche WebLink

Browse Search

.., �, TRINITY�ERD 15. For adhered membrane systems,side laps shall be minimum 2-inch wide sealed with min.1.5-inch heat weld. Unless otherwise noted,membrane adhesive application rates are as follows: Membrane Adhesive Method Rate VersiWeld VersiWeld Bonding Adhesive Contact(both sides) 60 ft/gal VersiWeld Aqua Base 120 Bonding Adhesive Contact(both sides) 120 ft/gal VersiWeld Low VOC Bonding Adhesive Contact(both sides) 60 ft�/gal VersiWeld Sure-Seal 90-830A Bonding Adhesive Contact(both sides) 60 ft/gal VersiFleece Aqua Base 120 Bonding Adhesive Wet lay(substrate) 120 ft/gal VersiFleece Hydroeond Water-Based Adhesive Wet lay(substrete) 100 to 133 ft/gal Full coverege at 100 ft/gal or Ribbons spaced as noted herein,spread to 2-3 inch,roof cover VersiFleece FAST 100,FAST 100LV,Flexible FAST Wet lay(substrate) set and rolled with 50 Ib roller. 16. For membrane systems attached using TPO 10-inch Pressure-Sensitive RUSS,the underside of the membrane which comes in contact with the tape shall be primed with TPO Primer. The membrane shall be secured by placing the primed portion onto the tape portion of the VersiWeld TPO 10-inch Pressure-Sensitive RUSS and roll with a steel hand roller to ensure contact. 17. For adhered membrane systems,unless otherwise noted: ➢ Reference to"VersiWeld"membrane below also includes"VersiWeld Plus"; ➢ Reference to"VersiFleece"includes 100 and 115; ➢ Reference to"VersiFleece AC"includes AC 120 and AC 135. 18. "MDP"=Maximum Design Pressure is the result of testing for wind load resistance based on allowable wind loads. Refer to FBC 1609.1.5 for determination of design wind loads. Exterior Research and Design,LLC.d/b/a Trinity�ERD Evaluation Report C35230.11.10-RS for FL14207-R6 Certificate of Authorization#9503 t Revision 5.06/19/2014 Prepared by� Robert Nieminen,PE-59166 Appendix 1,Page 3 of 36